I just want to thank you. This video is awesomely made, good instructions and awesome lighting! And i dont have a clue how you got some of the things done while holding a camera! Thanks once again!
I think I got this same issue. I Have a few questions. Did you drop any of the fluids? Oil coolant? Before doing the job. The aluminum oil filter housing fits a 3.6 2011 model. I hear that that upgrade is only for 2014 and later. Last, did you pressure tested before removing the original housing?
I have a 2011 and it's the same thing bruh it'll mix fluids when it goes bad like oil on coolant and coolant in oil so make sure to flush both thoroughly if that happens after you change it you'll need a few filters and some cheap oil just to run through the engine
@@thezekeprelliottexperience4907 I end up doing the job, the valley was full of coolant and the smell of cooked coolant was everywhere. with basic mechanic skills and some Harbor Freight tools it took me about a day of work to fix, saved money!
I damn near followed step for step and I have no clue what happened. Now my car is running super rough and now it sounds like it’s about to blow up. It’s was like misfiring making these loud pop noises. Idk what to do
How the Fuel Rail clip works (which is NOT shown here! - annoyed face): ruclips.net/video/Mw9kqo76JL0/видео.html I also went ahead and pulled the wiper cowl etc. off - makes LOT more room, but the little clips at each end of the wiper cowl (hold flexible rubber sections to the fenders) are insane stupid things that you cant avoid breaking 😞
I just want to thank you. This video is awesomely made, good instructions and awesome lighting! And i dont have a clue how you got some of the things done while holding a camera! Thanks once again!
Timely video Brother! I’m gearing up to perform this job. Thanks for the tip on the fuel line especially! Much obliged!
Wait.. was it 7 or 8 bolts on the intake?
I think I got this same issue. I Have a few questions. Did you drop any of the fluids? Oil coolant? Before doing the job. The aluminum oil filter housing fits a 3.6 2011 model. I hear that that upgrade is only for 2014 and later. Last, did you pressure tested before removing the original housing?
I have a 2011 and it's the same thing bruh it'll mix fluids when it goes bad like oil on coolant and coolant in oil so make sure to flush both thoroughly if that happens after you change it you'll need a few filters and some cheap oil just to run through the engine
@@thezekeprelliottexperience4907 I end up doing the job, the valley was full of coolant and the smell of cooked coolant was everywhere. with basic mechanic skills and some Harbor Freight tools it took me about a day of work to fix, saved money!
Where did you purchase the oil filter assembly?
Amazon
Was that 106 in lbs or 8.6 ft lbs for the housing screws?
Finally a good video
I damn near followed step for step and I have no clue what happened. Now my car is running super rough and now it sounds like it’s about to blow up. It’s was like misfiring making these loud pop noises. Idk what to do
Check for vacuum leaks
How the Fuel Rail clip works (which is NOT shown here! - annoyed face): ruclips.net/video/Mw9kqo76JL0/видео.html I also went ahead and pulled the wiper cowl etc. off - makes LOT more room, but the little clips at each end of the wiper cowl (hold flexible rubber sections to the fenders) are insane stupid things that you cant avoid breaking 😞
Did anybody else see the massive crack in the throttle plate?
49:00
Its probably a grease smear. You can see the throttle plate is clean at 6:45
I’m just