Incorrect greasing procedure. According to BMW TIS, no need to grease the sliding surface of the release bearing, instead only splines should be greased where the clutch disc slides with correct grease which is usually provided with new clutch plate assembly.
Hello, i done all buy youre video, when all put back and start car, i have big vibration and sound like my flywheel try to get out, bmw f31 same like you done, what can be the problem?
After I had replaced a new clutch set on my BMW E87 118D i have difficulties with 1st and reverse when the engine is running, when you drive everything is OK. Also when the engine is off you can smoothly change gears, you start the engine its hard to put it in gear, it goes but not so smooth, any suggestions ?
If it is the same enginecode, the procedure should be similar - otherwise we require your VIN to give a specific reply. Sincerely, Anders Marketing | Schmiedmann
you guys know your stuff best congrats guys
Incorrect greasing procedure. According to BMW TIS, no need to grease the sliding surface of the release bearing, instead only splines should be greased where the clutch disc slides with correct grease which is usually provided with new clutch plate assembly.
is the flex plate clutch preloaded or do you have to use especial tool to loaded??
Hello, i done all buy youre video, when all put back and start car, i have big vibration and sound like my flywheel try to get out, bmw f31 same like you done, what can be the problem?
Excellent video! Congrats
Is it the same process for the f30 335i??
Hallo guys just one question. Do we need to connect clip together on the clutch pressure plate(release bearing) ?
Is this procedure the same as for 2008 318D e91 143 hp ?
no loctite on the flywheel bolts ?
hello I want to know the brand of the special flywheel locking tool thank you
Great video, but the music was almost louder then the person.
After I had replaced a new clutch set on my BMW E87 118D i have difficulties with 1st and reverse when the engine is running, when you drive everything is OK. Also when the engine is off you can smoothly change gears, you start the engine its hard to put it in gear, it goes but not so smooth, any suggestions ?
Dual-mass .
Sam problem.
Y have changed only the clutch :(
What happen to clutch master cylender ?
Would a 440i clutch fit a 420d?
no
What size is the clutch alignment tool and where can I order one thanks
The tool has 2 diameters, one end of 15 mm in diameter and 20 mm in length and the other of 26.5 mm in diameter and 45 mm in length
..
gees , you could have cleaned the gearbox before installing all the new stuff
Er dette også gælende på F 10 /F11 520D ?
If it is the same enginecode, the procedure should be similar - otherwise we require your VIN to give a specific reply.
Sincerely,
Anders
Marketing | Schmiedmann
Do we need to bleed clutch cylinder ?
Nope, just take off the slave cylinder off the gearbox but don't open up any of the hoses \ pipes. It's not necessary
Here is a handy hint for the Flywheel ruclips.net/video/aR5deWog6-g/видео.html