everytime i thought i got to the funniest part of the video, i laughed harder, and harder, until finally, looking down at an anchor you had just epoxied, you say you may have made a mistake...then hearing the horn honk, looking up and seeing your kid in the car and going "speaking of mistakes" i fucking lost it. found your channel earlier today and have watched like 5 videos. thanks so much. have a yuengling for me.
Had to do that foam slab repair at work. The void under the slab was so large that cut an access hole and back filled with sand. A guy was inside with a wheel barrel, that how big. So it could have been worse.
Great vid! - So did the injected foam actually lift the floor in the low points or just fill in and keep it from dropping further? If the former, how did they control how much it raised it?
One thing that works better than threaded rods and epoxy is the Titen HDs. They are basically HUGE tapcons for concrete. Easy in, Easy out, SUPER hold. I defy you to find something it cant hold.
everytime i thought i got to the funniest part of the video, i laughed harder, and harder, until finally, looking down at an anchor you had just epoxied, you say you may have made a mistake...then hearing the horn honk, looking up and seeing your kid in the car and going "speaking of mistakes"
i fucking lost it. found your channel earlier today and have watched like 5 videos. thanks so much. have a yuengling for me.
Fascinating. Happy to see the workshop is no longer in imminent danger of collapse lmao
Great content man. It’s obvious you were either raised by someone who knew their shit or you really paid attention so far in life. Subscribed!
love the skits. this channel is going places
@4:37 You can really tell you have practiced that motion a lot. What a craftsman. 🤣
--craftsman-- woodworker.
fify
that was fun, thanks for letting me hang out in your shop.
Do you have a link for the inspection camera? That video quality is seriously impressive. Way better than the Klein USB one I use.
I’ve been very happy with it so far!
www.amazon.com/dp/B09NBRQ4ST?ref_=cm_sw_r_apin_dp_EZ0AT1T7RY42XZYN0Z5Z
@@thedoubtfultechnician8067 *NLA*
Had to do that foam slab repair at work. The void under the slab was so large that cut an access hole and back filled with sand. A guy was inside with a wheel barrel, that how big. So it could have been worse.
I'm glad you got it fixed. now i can go back to envying your shop. dammit i need more room.
Liked the video. Liked the humour. Subscribed.
Great vid!
- So did the injected foam actually lift the floor in the low points or just fill in and keep it from dropping further? If the former, how did they control how much it raised it?
One thing that works better than threaded rods and epoxy is the Titen HDs. They are basically HUGE tapcons for concrete. Easy in, Easy out, SUPER hold. I defy you to find something it cant hold.
I love your humor
I like that You use wood for fire insulation / insultation while stick welding. And You should try to blow and suck the same time the holes
Quality content and definitely not too esoteric!
I am crying after watching the intro 😂😂😂
love all your vid,s
" Hey Pluto !"
5:55 😂😂😂😂😂
6:00 😮😅😂
so many good jokes....
Sweet miata
I know one thing it can't do. Be used a second time if you have some left from the first use. 🤣
Was that the midlife crisis machine the Mazda Miata?
Can't seal rosie's o'Connell's yup shut...