Thorough and easy to follow. Not recommended for beginner DIYs as this level assumes you know how to do some basic stuff already, but if you do this is quite well done. Thank you 🤙 got my 2011 Avalon straight.
Look at that floor jack , also car needs to be level to insure the fluid will be the right amount after you run the engine to warmup fluid and drain to proper level
Nice work. Just make sure the car is perfectly level when checking the fluid level. I couldn’t tell if yours was level or if one corner was still jacked up on a jack stand
6 speed ATF is relatively easy. Can you please show us how to do the 8-speed ATF filter change? It has a filter pan on tHe side, not a drop down pan like the 6 speed transmission has. Thank you.
for best and accurate filling procedures, check AMSOIL lookup website. www.amsoil.com/lookup/auto-and-light-truck/ and measure the oil you remove to make sure you’re not under-filing the transmission.
does this procedure apply to a 2019 toyota rav4? I heard that using a wire to jump the OBD2 connection is important to do as well unless you use a temp scan tool.
وعليكم السلام، المجموع ٧ علب زيت. هذي الاهواز تكون راكبة في مبرد زيت القير، تفك واحد منهم و تسحب الزيت القديم اللي باقي داخل القير و اهواز المبرد عن طريقة.
Hello! When purging from the transmission cooler line, does the old oil stop running at some point by itself or at what point do you stop it? Also does removing the valve body to remove more dirty oil make a difference or no? I look forward to hearing from you. Thanks
Would you do the same with engine oil well? Fluids must be changed at specific time based on the manufacturers. When it loses its viscosity over time you allowing more friction to happen and increase the wear of gears inside.
This is 2016 Toyota Aurion with U660E 6-speed transmission. If not mistaken, you have the same transmission as well(you need to confirm that). If you have U660E, the procedure is the same. You can inspect the oil, if you have metal shavings don’t flush the oil and try to change 1 quart every week. Then after 3 months you can change all the fluid without flushing. This is the procedure I use to be safe.
@ardie72 lol okay....i just dont have time to be doing all that bs using a thermometer etc. thats doing too much. drain the fluid cold measure what comes out and put the same amount of new cold fluid back in
What is "OIL COOLER LINE"? 9:50 - DISCONNECT THE "OIL COOLER LINE" TO DO THE FLUSH. Hello Ahmed Al Towaileb You have mentioned "OIL COOLER LINE" int the clip. Is that the "coolant oil" or "transmission oil" ?
Thorough and easy to follow. Not recommended for beginner DIYs as this level assumes you know how to do some basic stuff already, but if you do this is quite well done. Thank you 🤙 got my 2011 Avalon straight.
So how you do the level?
I know how to do it but just wanted to know what’s your idea of doing it.always use the scanner for the temperature
I like it. Working in the street...get it done where you need to. Working into the night til it's done right. Nice.
Look at that floor jack , also car needs to be level to insure the fluid will be the right amount after you run the engine to warmup fluid and drain to proper level
Please note...the bolts holding the filter are different lengths.Pay attention which one goes where.
Music was absolutely fire. 💯
nah, its trash
Best video so far on this. Ty guys so much about to do mine .
Nice work. Just make sure the car is perfectly level when checking the fluid level. I couldn’t tell if yours was level or if one corner was still jacked up on a jack stand
Very thorough procedure, thanks for sharing! I have the es350 Lexus and was definitely looking for something like this. 🙏🙏🙏
Glad that the video was helpful for you!
👍🏼👍🏼👍🏼 Thank you my friend that was a well done video on this trans service. 🙏🏼
How many liters of oil for the gearbox?
In the UK cars have anti theft bot on the tryes, so that you can not remove tryes yourself.
Muy bueno ,excelente 😅
6 speed ATF is relatively easy. Can you please show us how to do the 8-speed ATF filter change? It has a filter pan on tHe side, not a drop down pan like the 6 speed transmission has. Thank you.
how many quarts of oil fluid you add? thanks great video
7 quarts
thank you
Recently had to. Hanged the filter on ,y 10 year old transmission. Filter was restricting oil flow.
This was very helpful for me...thank you!!
Glad it was helpful!
Good job young lads!
Which gear oil i can use in Aurion 2008
How did you determine the fluid temperature? Does it matter if it is hotter or cooler?
How many quarts come out with the filter change?
How many liters of oil do I need for this procedure, thank you very much
for best and accurate filling procedures, check AMSOIL lookup website.
www.amsoil.com/lookup/auto-and-light-truck/
and measure the oil you remove to make sure you’re not under-filing the transmission.
does this procedure apply to a 2019 toyota rav4? I heard that using a wire to jump the OBD2 connection is important to do as well unless you use a temp scan tool.
To be honest, I have no idea about Rav4. Sorry.
Pretty much it does apply but u have to find your transmission cooler return line connect clear hose to it.
40-45 Celsius which means the car is cold right? I mean the temperature gauge is cold
I don’t think the dealer does this, they just flush out the system very good video
سلام عليكم كم علبه اخذ
وكيف اسوي الطريقه اللي سويتها عشان يطلع كامل الزيت من جهه الرديتر لانه غير واضح
وعليكم السلام،
المجموع ٧ علب زيت.
هذي الاهواز تكون راكبة في مبرد زيت القير، تفك واحد منهم و تسحب الزيت القديم اللي باقي داخل القير و اهواز المبرد عن طريقة.
@@ahmedaltowaileb جزاك الله خير
Hello! When purging from the transmission cooler line, does the old oil stop running at some point by itself or at what point do you stop it?
Also does removing the valve body to remove more dirty oil make a difference or no?
I look forward to hearing from you. Thanks
Until you see oil color change to cherry red, removing the valve body will not remove more oil nor dirt.
@@ahmedaltowaileb Thank you so much 🙏🏾🙏🏾🙏🏾
How many liters of oil do I need for this procedure, thank you very much
@@marcosvillalba7639 I would say it’s best to have 8 quarts available.
Hi,I would like to know how many ATF need for change like that?,thanks
thank you Ahmed. Ramadan Kareem!
Ahmed, does this method get all the old oil out?
From what I observed, yes it does
@@ahmedaltowaileb the oil you replaced was still red. You could of drove longer on it? But the pan sure needed cleaning.
@@mgomez5606 i follow major maintenance intervals, every 80k km.
As long as your transmission works ok don’t do any fluid change.I did mine and now it has hard shift issues.
Would you do the same with engine oil well?
Fluids must be changed at specific time based on the manufacturers. When it loses its viscosity over time you allowing more friction to happen and increase the wear of gears inside.
There is huge difference between engine oil and transmission fluid.i change my engine oil very frequently
@@AftabAli-qp2qr do the same thing with the other lubricants as well, they need to be changed frequently. Over time they will lose viscosity.
Was it U660E transmission? What oil did you use?
You should drain pan(half the fluid) every 30k miles, then change filter at 100k. It best to use Toyota WS transmission fluid or equivalent.
What about the bolts that the crossmemeber is covering?
you can get around with a Flex-Head Ratcheting Wrench
Excellent video!
About how many quarts did you put back in? 4 quarts?
oil pan holds 4 quarts, if you are doing complete flush you will need 7 quarts.
@@ahmedaltowailebbuen día, 7 cuartos cuanto sería en litros muchas gracias
6.62 Liters@@marcosvillalba7639
Since this trans had a dipstick originally can it be added and the overflow tube removed?
I have no idea honestly, but you can try
Hey friend what transmission is yours? I have a 2.5L 2010 Camry LE. Will the procedure be the same as yours? Thanks.
Also I have almost 90k miles on my Camry. Should I change the filter and fluid now? Will it hurt anything since I’ve never done it before.
This is 2016 Toyota Aurion with U660E 6-speed transmission. If not mistaken, you have the same transmission as well(you need to confirm that). If you have U660E, the procedure is the same. You can inspect the oil, if you have metal shavings don’t flush the oil and try to change 1 quart every week. Then after 3 months you can change all the fluid without flushing. This is the procedure I use to be safe.
@@ahmedaltowaileb I do have the u660e in mune
@@ahmedaltowaileb is 90k to late? It’s my moms car btw
@@ahmedaltowaileb wow that’s smart change a quart per week until 3 months and then swap out all the fluid. Nice!
hi,what is the oíl fluid ,specification ,sinthetic?
I used AMSOIL Signature ATF
Toyota WS transmission fluid or equivalent, should be full synthetic.
Tank you🙏❤️❤️
Are you based In Jeddah, KSA??
You didn't set the level correctly after reaching operating temperature. ..
That should be shown here
level doesnt have to be perfect, just put around the same fluid back in as you took out and youll be good
@@cantwealljustgetalong2 if you are a novice that cuts corners , yes you are correct
@ardie72 lol okay....i just dont have time to be doing all that bs using a thermometer etc. thats doing too much. drain the fluid cold measure what comes out and put the same amount of new cold fluid back in
@@cantwealljustgetalong2 yeah only mechanics can
What is "OIL COOLER LINE"?
9:50 - DISCONNECT THE "OIL COOLER LINE" TO DO THE FLUSH.
Hello Ahmed Al Towaileb
You have mentioned "OIL COOLER LINE" int the clip. Is that the "coolant oil" or "transmission oil" ?
Hi, it’s transmission oil line that is going to the transmission oil cooler.
What's the torque on the filter bolts?
96 lb.in
@@ahmedaltowaileb That's 8ft/lbs. Thanks!
🙌👍👍
Easy money
Very well done sire just one thing that's not professional don't look directly at the camera
Thank you so much sir, really appreciate your tips and support!
Stopped watching the minute I heard the loud music - so profoundly distracting and juvenile
tell us what you are doing, then cut the stupid music which is of know help period.
Glad these fellows are wearing the required open toed flip flops for safety