You can buy a box of around one dozen or so carby gaskets from some companies, I think it’s jax max here in Australia, they are probably Chinese they seem to match the holes well but don’t look anything like the original. I have used them a few times on older saws and the seem to work ok. Cheers and stay safe.
When I spray break cleaner on carburetor membranes or near intake boot it always bogging down or stalling even if membranes or carburetor are new. I tested on my 4 chainsaws (which running pretty good) do you know why ? If I test it on crank seals or base gasket it does not bogging down 🤔. Thanks !
That is pure experience (and intelligence) of decades showing! I really enjoyed watching how you methodically approached the problem. Thank you!
Very informative video Leon. Thanks for your troubleshooting diagnostic skills. You are very patient!
For some reason you haven't been coming up on my feed glad to see you again nice work .
You can buy a box of around one dozen or so carby gaskets from some companies, I think it’s jax max here in Australia, they are probably Chinese they seem to match the holes well but don’t look anything like the original. I have used them a few times on older saws and the seem to work ok. Cheers and stay safe.
U sir are very good at what you do.
Awesome work
Brake clean is my go to tool for air leaks. Super sleuthing Leon. Thanks
Thanks for the lesson.
I noticed that you didn't retest with contact cleaner on camera. Why? Because it still stall the saw.....
Where do get the parts to replace the check valves in carbs?
Like the color combo good-looking low low hours.
Leon, how's the screw between the bar studs?
Any movement between in The Handlebar bracket?
Great video. Where did you get your hand held tach?
When I spray break cleaner on carburetor membranes or near intake boot it always bogging down or stalling even if membranes or carburetor are new. I tested on my 4 chainsaws (which running pretty good) do you know why ? If I test it on crank seals or base gasket it does not bogging down 🤔. Thanks !
Leo need your info I got a saw I want you to work on it’s s homelite little red.
brake cleaner can be the best troubleshooting tool
Can WD-40 be used?
Have you had a homelite 330 run away?
So where is your shop I would like to send you my saw
Sure looks like you know what you are doing I have a super 922 homelite it started on choke then quit
sounds a lot better stick in a log now