How did you get that return spring to set in properly mine doesn’t seem to wanna stay in the hole and pops out a little bit when I test it with the kick start lever. Any idea or advice? I have a 99 yz250 I’m pretty sure they are relatively similar.
This spring better not come out of place. I’m hoping this clutch basket ensure that it cannot come out but seems like a part that can be upgraded. Everything else seems pretty stout but if that spring comes undone it can mash the gears unevenly causing catastrophic damage which I do not want
I have noticed the last few rides that when I am warming my bike up the kick starter has been moving up and down with a grinding sound. I wait a few minutes and try again and the issue goes away. 2018 yz250x.
At 1:39 the part beside the nut. That’s goes after I put the clutches and clutch face back on right ? It doesn’t go in before I put clutches or clutch basket on right ?
could anyone know it is kick starter shaft from dt 125 fit to yz 125 1999? Mine is broken and it cannot be weld cause its ripped off on cutters. In Poland they are few but uncomplete and they cost like 120 $ I dont know what to do
Thank you so much for this, snapped mine on my YZ125 and couldn’t find a video anywhere.
How did you get that return spring to set in properly mine doesn’t seem to wanna stay in the hole and pops out a little bit when I test it with the kick start lever. Any idea or advice? I have a 99 yz250 I’m pretty sure they are relatively similar.
Hey drew thanks for this video. I have just had a similar thing happen. 😢 this really helped.
Seems like a somewhat comonn issue. I'm no pro but glad it helped.
This spring better not come out of place. I’m hoping this clutch basket ensure that it cannot come out but seems like a part that can be upgraded. Everything else seems pretty stout but if that spring comes undone it can mash the gears unevenly causing catastrophic damage which I do not want
Okay? Your opinion😂 and if you run over a nail now you have a flat tire, how would that pertain to us?
I have noticed the last few rides that when I am warming my bike up the kick starter has been moving up and down with a grinding sound. I wait a few minutes and try again and the issue goes away. 2018 yz250x.
What was the problem?
What was the problem?
At 1:39 the part beside the nut. That’s goes after I put the clutches and clutch face back on right ? It doesn’t go in before I put clutches or clutch basket on right ?
The push rod goes on after the nut. It goes on before the Outer clutch basket. Double check a partsfische if needed.
@@motodrew295 I got it thanks
could anyone know it is kick starter shaft from dt 125 fit to yz 125 1999? Mine is broken and it cannot be weld cause its ripped off on cutters. In Poland they are few but uncomplete and they cost like 120 $ I dont know what to do