How to clean and setup the CUISINART COFFEE CENTER BARISTA BAR 4-IN-1 COFFEEMAKER - step by step!
HTML-код
- Опубликовано: 8 сен 2024
- Watch me unbox and setup the CUISINART COFFEE CENTER® BARISTA BAR 4-IN-1 COFFEEMAKER! ☕️
I’m sharing the step by step process of cleaning it with the charcoal water filters before your first use. Everything you need to know! I read the directions so you don’t have to. 😅
Shop through my amazon affiliate link here - amzn.to/471ULW0
#kitchenappliances #amazonfinds #amazonkitchenproducts #amazonkitchenitems #cuisinart #coffeemaker #coffeecorner #coffeemachines #espressomaker
Thanks for this!! Exactly what I was looking for.
Thank you SO MUCH for doing this video! Just received mine today and I was dreading the whole "set up" part. Easy to understand your video and a huge help! Much appreciated!
That makes me so happy to hear!! (: Happy to help!
I agree! Just brought mine home today!
Mine is a lot louder than I expected, on the pod/espresso side. Did you experience that too?
@@davidzukowski Mine only seems loud when I steam the milk (frother)
Thank you.
I could not figure out why I couldn't get the pot to brew until I saw you pour water into the pot and into the separate side tank.
That was 2 hours of torturing my new coffee maker.
Thank you, thank you!!! 🌹
Same!! Lol it took me a while to figure it out but happy my video helped you out! 💕
I have purchased 2 of these brewers in the past month-Both failed during a espresso brew with error E0. Afterwards, the handle would not disengage and was locked. I assumed the first unit was defective and sent it back for replacement. After happening again with second unit I took a closer look to determine problem. (I also wanted to retrieve my reusable k cup pod) .If you cycle the machine turning pod brew on and off you should hear a click. That is the release of the handle locking mechanism. You need to pull the handle with considerable force- I actually put it on the floor pushing down on the lid while lifting on the handle. Upon inspection internally, it is apparent that the top piercing prongs did not perforate the top foil cone. This caused excessive pressure inside the machine and deformed the pod creating internal pressure against the locking cam. I have to think this will happen to others. It is important to make sure the top of the pod is spherical and not deformed. I close the unit and then reopen to make sure the pod is properly seated before actually brewing. Hope this helps!
Interesting! Thank you for sharing this. I have not noticed that, but I will keep my eye out for it!!
Were you able to do the cleaning/setup cycle without the pod without getting the EO error? I’m trying that now and can’t get it to even run water through on the nespresso setting. Sounds like the pump tries to start and then I get the error.
I bought one for a Christmas present, had to return, silicone seal around coffee pot started to peel. Checking to see if you also noticed this ossue.
I have not noticed that, but I will keep my eye out for it!! Thanks for sharing!
Could you help me? I would like to know if I can use reusable k pods?
nice set up! wow you're pretty!
Glad you enjoyed the video!
You did NOT cover how to set the time and the brew time 😣