J Tech Photonics Laser Post Processor Installation for Vectric Products

This is a brief overview of how to install a post processor in the Vectric version 11 software. It details installing a post processor for using a "laser end mill" and the quick engrave toolpath as well as installing a post processor for the new Vectric Laser Module plugin and using the laser cut and fill toolpath.
Laser Endmill Post Processors
jtechphotonics...
Laser Module Post Processors
jtechphotonics...
More information on products available at:
jtechphotonics...

[@abeedcactus3749]

Thank you your information solved my problem .

[@chrispelletier3661]

Hello. I just purchased the 24 watt laser and just want to confirm that the setup in this video is the same for the 24 watt and the Onefinity elite series with Masso controller?
Thanks!!!

[@solution2two]

Any idea where to get a material test card for vectric laser module? There are a million for light burn but nothing for vectric.

[@xntryk28]

Help, I have the laser module and I followed these steps, but the laser does not come up in the tool selection it is listed in the post processor selection box, but choices for 7 w, 14w and feed rates do not populate. Thank you.

[@josephschneider5459]

I have the same issue. Any luck on this?

[@xntryk28]

@@josephschneider5459 no, I had to add it manually from the jtech specs on their website

[@QuebecoisSti]

For Centroid/Acorn, use this video (hopefully still works good): ruclips.net/video/bMN7kDUnpWE/видео.html
I should now invest in one Jtech laser since I am running Centroid Acorn