Homemade sawmill power feed on a Norwood HD36V2

Gave my homemade power feed its first test run. I think it was successful.
Used a motor off of a jazzy wheel chair and the controller consists of 2 motor speed controllers, a bunch of relays and switches.
Replaced the Norwood power head switch with one of the speed controllers and an up/down switch. Now I can easily make fine adjustments.
Also added a switch to start and stop the engine.
Throttle & coolant is controlled by an actuator connected to the manual throttle.
Limit switches were added to the front and back of the carriage. Automatically stops at both ends of the mill.
Also added a remote to start and stop the mill and a 12v voltage meter/ USB charging port.
#homemade #norwood #hd36v2 #powerfeed #sawmill #controller

[@aggiesimon6800]

Nice job 😊