@@Ignitions me personally? Yes, moving the vfd far away and using a shielded usb cable was helpful. Also making sure windows does not put the usb ports in power saver mode.
I need help. commands and e-stop work for me, so the machine is rusting ... I need help how to activate the e-stop mushroom and limit switches .... THANK YOU
I never managed to figure that out, and I had done allot of research and turns out the Novusun controller is very bad when it comes to PWM, I managed to get as far as setting it up, however 100% was reversed and meant 0% turned the spindle onto full power
I had the same problem, I solve that giving permisions of the firewall. You have to add Mach3 to the list of allowed programs
You saved my day! 👍
Good video. Do you know how I can configure the index?
for the laser, What pin/wire gives you PWM output
If the IP address is random. How do I find out what it is?
Does anyone have this board's bin file?
How can I get the IP address for my control board
hello my Novusun v2 does not open the serial number. Could this be the cause of the controller itself? Thanks.
I have the NVUM (usb) and sometimes it disconnects, probably due to emi on the extension cable. Do you ever have problems with NVEM?
Replying on my company account, yes I had. My VFD was too close to my NVEM board and causes problems. I moved it 2 meters away and solved it
i have the same problem with nvem .somethimes work and disconects.you solve this?
@@Ignitions me personally? Yes, moving the vfd far away and using a shielded usb cable was helpful. Also making sure windows does not put the usb ports in power saver mode.
I need help. commands and e-stop work for me, so the machine is rusting ... I need help how to activate the e-stop mushroom and limit switches ....
THANK YOU
Hello !!!
Please show how to connect and control PWM
Thank you
I never managed to figure that out, and I had done allot of research and turns out the Novusun controller is very bad when it comes to PWM, I managed to get as far as setting it up, however 100% was reversed and meant 0% turned the spindle onto full power
@@CasperRound Thanks for the answer.
I need PWM to control the laser power
I don't know how to set pin or port numbers in mach3.
Everything else works
OH my Gosh! Thank you!!!
Your welcome :)
To vast to shakey
Want me to create a new video?
@@cncspace7738 yes i try to understand but i don't see anything
i want to know how to connect my NVCM62.1, i am able to connect a mach3 usb at $ 13, and i am unable to plug this one. can you help me.