Traxxas XL5 Lipo mode

Поделиться
HTML-код
  • Опубликовано: 10 сен 2024

Комментарии • 57

  • @blue11fight71
    @blue11fight71 2 года назад +6

    Dude thank you so much! I had my LiPo on NIMH and then I when I got it on LiPo mode I had it on the kid mode. You are a life saver.

  • @MajorProblem698
    @MajorProblem698 Год назад

    This is the best most knowledgeable video on the internet. As I just got the lipo and wanted to switch modes and did not know how.

  • @simeonzuev8773
    @simeonzuev8773 3 года назад +5

    Im new to rc cars and this helped me a ton. thank you.

  • @TheCallofDoodie
    @TheCallofDoodie 3 года назад +2

    Thanks dude! I lost my instructions and just switched to LiPo. Super helpful.

  • @jacobphilips5209
    @jacobphilips5209 3 года назад +3

    Thanks. I bought my traxxas used and had no idea of the other features

  • @Krapper515
    @Krapper515 13 дней назад

    Thanks! I just bought my first ever Traxxas! All the Arrma trucks use a little jumper to switch modes, so I was curious how to switch this! Excited to try mt new Slash XL5

  • @PIZZA_and_NITRO
    @PIZZA_and_NITRO Год назад +1

    Thanx, best vid on the subject🏁

  • @watchingyoutoo7955
    @watchingyoutoo7955 3 года назад +3

    Just the video I needed as a noob rc dad

  • @frogman4201
    @frogman4201 2 года назад +1

    I just bought a 4000MAH lipo 3s battery. I still have a stock motor and setup I just changed the battery but it blinks green and red? It only steers, it doesn’t go forwards or backwards, any answer’s?

    • @robertvaczko
      @robertvaczko 2 года назад +1

      This ESC doesn't run with 3S battery. 3S is for all above, incl. brushless controllers. I picked up this noon my new 2S LiPo-s, those are the maximum for stock XL5 controller.

    • @frogman4201
      @frogman4201 2 года назад +1

      Yea thanks I figured that out a little bit afterwards. The stock esc will only let you use up to 8.4 volts, you can’t run a 11.1 volt on an 8.4 volt setup

  • @NelaRc
    @NelaRc 3 года назад +2

    Thank you so much been a while and forgot how to switch it

    • @davisloco5779
      @davisloco5779 2 года назад

      What does it mean if it’s blinking?

    • @NelaRc
      @NelaRc 2 года назад +1

      I found that mine were shot over heated at one time and burnt it. Immediately goes to shut down.

  • @victormorales5548
    @victormorales5548 Месяц назад

    When I put it on the first blink mode it goes full throttle for a bit, after a couple seconds it starts going slower and blinking red, do you know why it does that?

  • @ItsBuuild
    @ItsBuuild 3 года назад +1

    Your the biggest help for me I fried my nimh battery In lipo mode this is cool thanks know so that does not happen thanks

  • @tothehunt
    @tothehunt Месяц назад

    Thank you

  • @RaviSingh-tv5lw
    @RaviSingh-tv5lw 2 года назад +1

    Hey bro i have few questions about my traxxas E-Revo 2.0 can you please help me out. Feom this video seems like you know your stuff. Please help. I jist started this hobby and im lovin it.

  • @stevebrown1104
    @stevebrown1104 Месяц назад

    Thank you man!

  • @dripxpansion9451
    @dripxpansion9451 3 года назад +2

    That helped a lot
    Thanks man 🙏

  • @RAULHERNANDEZ-um5fm
    @RAULHERNANDEZ-um5fm Год назад

    Thanks a lot.

  • @user-do7pu3qf9j
    @user-do7pu3qf9j Год назад

    Very NEIC..

  • @tyleramberry8472
    @tyleramberry8472 3 года назад +1

    What battery did you plug in for it to work

  • @axweilder0825
    @axweilder0825 Год назад

    Thx

  • @jemotorsports00e
    @jemotorsports00e 2 года назад

    What does it mean when mine continues to blink the green light?

  • @themotorcyclezeroshow
    @themotorcyclezeroshow 3 года назад

    Thank you!

  • @sloppie5257
    @sloppie5257 3 года назад +1

    Ok so today I drove my rustler in the water I was so glad it it waterproof and a vxl 4+4

  • @masonwells8025
    @masonwells8025 3 года назад

    I just tryed this and I try to set it back to my nimh and it won’t work help plz

  • @cityofsinrc7028
    @cityofsinrc7028 3 года назад +1

    What if the ESC keeps blinking red and green red and green after I hold the button down

    • @dezoner9792
      @dezoner9792 3 года назад

      that means you are using a nimh on lipo mode or ur using a lipo on nimh mode

  • @thecrazycarchannel709
    @thecrazycarchannel709 3 года назад +1

    Can you do this with 3s safely or will it overheat ?

    • @Greysonszokoly
      @Greysonszokoly 3 года назад +1

      3s will overheated the car if you want to run 3s on xl5 you need to buy the trx4 sport 3s xl5 esc

    • @CarlosC882
      @CarlosC882 3 месяца назад

      ​@@Greysonszokoly Even if u use the kid's mode?

  • @stickboyfpv4742
    @stickboyfpv4742 2 года назад

    Difference btwn 1:07 and 2:38?! You hold button the same... but at 1:07 it changes esc modes, and at 2:38 change battery mode??

    • @fletchersfixit6358
      @fletchersfixit6358  2 года назад

      for esc modes u hold the button when its off for lipo u tern it on then hold the button

  • @dxlind1184
    @dxlind1184 2 года назад

    Worked

  • @mr.chapel4179
    @mr.chapel4179 3 года назад

    My brand new Traxxas (Bigfoot no.1) issonet react to eny thing tried this, and other thing and it not just cant do anything mine is just fast blinking red/green I was enable to get the 2 and the 3 bip, like in on traxxas site,but nothoing. Then I re binded with the controller, than guess what, the stereing work and still fast blinking the 2 color, so fast it is impossible to catch one.
    Also with nimh battery no matter what 5-6 minutes and after 3 minuts it alrready lost the power. My battery in the controller is new, also I always use storager mode.
    Ohh and one more thing, the Traxxas batter what was in the box, give me 4-5 solid meters and off.
    I guess the esc is just bad, doesn't work and also this one probably sitting years on the self and the battery and the esc is off now. I'm so mad bc is I send it back either I get a same old one or they say it is okay...I would tell them to try it with lipo and nimhon the pad it is okay just see if it works and how long the battery going.
    Mad af :(

  • @chrisbrandt2793
    @chrisbrandt2793 4 года назад +1

    This wont work with 3s right?

  • @Z4vier1008
    @Z4vier1008 2 года назад +1

    Why dose mine blink green and red

    • @fletchersfixit6358
      @fletchersfixit6358  2 года назад

      If the Low-Voltage Detection (LVD) is "ON" when a nickel-metal hydride (NiMH) battery is used an ESC may show the over-voltage alarm, indicated by a flashing red and green light. ... If you have a Lithium Polymer (LiPo) battery, connect it to the ESC and turn it on.

  • @freemee4327
    @freemee4327 Год назад

    Does this work for the Russell x L5?

  • @alexace2575
    @alexace2575 4 года назад

    I bought a 3s lipo gold bar battery and tried doing the same with my rustler and it wont work can some one help me, it stays flashing red and when hold to turn to lipo mode I'm only allowed to use my steering servo and no motors??

    • @kyleellis262
      @kyleellis262 4 года назад +1

      Having the same issue and can't find anything on it. Bought a 2s and switched to lipo mode but when I hit the throttle the green light turns off until I go back to neutral. Only have steering 😣

    • @angryyank
      @angryyank 4 года назад +2

      Sounds like you and kyle below may have to reset the transmitter... It sounds like its out of callibration to fix.... First turnoff the ESC then turnon radio first then hold down ESC button till the light turns red then flashes red once then letgo of the esc button instantly....... Then on the transmitter pull the trigger to full throttle then wait for the ESC light to flash red twice, Then do the same procedure to set your reverse then letgo of the throttle so its in neutral then test both throttle and reverse again it should correct it..... Cheers

    • @angryyank
      @angryyank 4 года назад +2

      Sounds like you may have to reset the transmitter... It sounds like its out of callibration to fix.... First turnoff the ESC then turnon radio first then hold down ESC button till the light turns red then flashes red once then letgo of the esc button instantly....... Then on the transmitter pull the trigger to full throttle then wait for the ESC light to flash red twice, Then do the same procedure to set your reverse then letgo of the throttle so its in neutral then test both throttle and reverse again it should correct it..... Cheers

    • @alexace2575
      @alexace2575 4 года назад +1

      @@angryyank thank you man I'll try this when I get off work tonight ill update once I get home!! Thanks again

    • @angryyank
      @angryyank 4 года назад

      @@alexace2575 Yw... I hope it helps yo out and gets your rig back on the road again if it does not contact me and maybe I can walk you thru some other steps to get her goin again..... Cheers

  • @aztecaloza
    @aztecaloza 3 года назад

    Bro I don’t have the charger to charge the battery so what do I do and I lost my controller

  • @RaviSingh-tv5lw
    @RaviSingh-tv5lw 2 года назад

    Let me know if i can get in contact with you bro

  • @dannythomas7902
    @dannythomas7902 4 года назад

    Saved my ass from boy smashing it