Thanks for creating this video Jim and Cindy!!! I appreciate you guys! Did you end up putting any spray foam back underneath the van around the hole? Or any of the putty or sealant there instead or only on the inside? Also, how are you taking off the top wood panel that covers the wires behind the ecoflow? It looks like you have a screw there that you unscrewed to get it off, but mine does not have any screws there. I tried slipping a flathead screwdriver in the edges to try and pry it open. Thanks again!
H again, good questions! I did put putty in to fill the gaps on both the top side of the hole through the floor, and from the bottom as well. Then I used the black silicone on the inside and I did put a circle of spray foam back underneath as well. As far as than panel behind the batteries, ours has one screw on each side so we can easily take it off. Unfortunately I don't know how yours is attached if you don't have screws there, hopefully you can figure that out. Good luck!
Hi there! Thank you for your question. Everything is controlled in the mobile app... Start your van normally. Then, when you are ready, driving etc, turn on the alternator charging to feed the Ecoflow system.. best to do it when the house batteries are charged up. Then start charging up the Ecoflow. Does that help?
If you are feeding 12v power from Ecoflow to the house batteries ("reverse charge mode") then yes I would turn that function off before starting the van. Once you have the van running the house batteries will charge from the alternator instead. And in the app you can switch to regular charge mode recharge the Ecoflow also.
Thanks for creating this video Jim and Cindy!!! I appreciate you guys! Did you end up putting any spray foam back underneath the van around the hole? Or any of the putty or sealant there instead or only on the inside? Also, how are you taking off the top wood panel that covers the wires behind the ecoflow? It looks like you have a screw there that you unscrewed to get it off, but mine does not have any screws there. I tried slipping a flathead screwdriver in the edges to try and pry it open. Thanks again!
H again, good questions! I did put putty in to fill the gaps on both the top side of the hole through the floor, and from the bottom as well. Then I used the black silicone on the inside and I did put a circle of spray foam back underneath as well. As far as than panel behind the batteries, ours has one screw on each side so we can easily take it off. Unfortunately I don't know how yours is attached if you don't have screws there, hopefully you can figure that out. Good luck!
I may have missed something watching your video. Do you have to switch anything over before you start your van
Hi there! Thank you for your question. Everything is controlled in the mobile app... Start your van normally. Then, when you are ready, driving etc, turn on the alternator charging to feed the Ecoflow system.. best to do it when the house batteries are charged up. Then start charging up the Ecoflow. Does that help?
If you are feeding 12v power from Ecoflow to the house batteries ("reverse charge mode") then yes I would turn that function off before starting the van. Once you have the van running the house batteries will charge from the alternator instead. And in the app you can switch to regular charge mode recharge the Ecoflow also.