How To Replace the Clamps On A Battery Charger

[@marycore2761]

He goes off screen and you can’t see what he’s doing.

[@royhoco5748]

I would put a little solder on the wire and clip make a good solid connection

[@stevenmccoslin4511]

Adjust ur camera and clean ur table off

[@MrMauricio1947]

Some one gave me a shop battery charger with no clamps, how do I know what cable is the positive?

[@karareyes3910]

What wire size did you use?

[@lexmarks567]

I didn't replace the wires just the clamps. The wire is factory and original.

[@alfredslone4856]

If u have a charger that has both terminals removed how do u tell which is which

[@JArtMiller]

That is my question I'm trying to answer.

[@Devilspocket2002]

@@JArtMiller use a volt meter. if it shows -12 volts then its backwards positive 12 volts means its correct

[@JArtMiller]

@@Devilspocket2002 Thank you for your reply. After I thought about it, that's exactly what I did. Thanks gain....JAM

[@trinketstuff418]

Volt meter

[@Hazeltonpeakroad]

Would be ok but most of what you do is off camera.

[@betmon5986]

I use a lighter to take the insulation off , much better and faster for me anyways