Don't Panic! - How To Remove A 3D Printer Hotend Blob Without Causing Any Damage.

In this video i'm going to show you how to safely remove a hotend blob from your 3d printer without causing any damage.
Firstly, don't panic.
It can be quite easy when you see something go so obviously wrong with a print to immediately start pulling on the melted mess or cutting away parts.
This is nowhere near as bad a problem as it looks and, if you are careful, you may get away without replacing anything and be back printing within about 10 minutes.
..............................................................................................................................................................
BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.
www.buymeacoff...
You can also use the RUclips 'Thanks' button above if you prefer.
...............................................................................................................................................................
Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)
Silicone Socks
Mk8 (Creality Ender, CR10, etc.)
US amzn.to/3nCBqX3
UK amzn.to/3OOiAIs
Mk10 (Makerbot, Flashforge, etc.)
US amzn.to/3OY5NTs
UK amzn.to/3IaIJyL
Volcano (Anycubic Vyper, Artillery Sidewinder)
US amzn.to/3aay9eH
UK amzn.to/3y1HGMQ
V6 Official (Prusa, Ultimaker)
US amzn.to/3bJmCU3
UK amzn.to/3Aj8Y48