You Must Calibrate Your CNC for BEST Performance!

A different leadscrew changes the settings and ruins your projects. You MUST calibrate the x axis after the upgrade on the XE-PRO 8040.
Please consider supporting the companies that support this channel.
xTool.com site: store.xtool.co...
FOXAlien: www.foxalien.c...
Support my channel on Patreon: / pawpawsworkshop
Direct donations support my channel: www.paypal.me/...
Easel: www.inventable...
X-Carve: www.inventable...
CNC4Newbie: cnc4newbie.com...
STARBOND GLUE: www.starbond.c... 15% OFF PROMO CODE pawpawsworkshop15
DEWALLIE.COM: dewallie.com?aff=6
Made the Best.com: www.madethebes...?aff=111
CUTECH TOOL, LLC: cutechtools.us?sca_ref=3295975.wWzLfJctEu
=============================
Comments or questions My email is:
[e-mail]
Official Website: www.sainsmart....
Link to Laser: jtechphotonics...
CNC4NEWBIE: cnc4newbie.com
Demon Controller By Designs by Phil:
cnc4newbie.com...
AMAZON AFFILIATE LINKS:
As an Amazon affiliate I earn from qualifying purchases. Purchases that you make help to support my channel.
Sculfun S9 Laser: amzn.to/3KB018p
Genmitsu PROVerXL 4030 amzn.to/3xPdgMP
FOXAlien 4040xe link: www.amazon.com...
Replacement brushes for DeWalt 611 Router: amzn.to/2Sknovz
DeWalt 611 Router: amzn.to/2Sp7H6l
90 degree v-bit: amzn.to/2WspRDf
60 degree v-bit: amzn.to/2sYTK0k
Freud bottom cutting bits: amzn.to/2H30R00
Router Bit Set: Router Bit Set 1/4" Shank: amzn.to/2G4iQDH
Oramask 813 12"x10' Roll amzn.to/2VrrUe5
Oramask 813 12"x20' Roll amzn.to/2ViovxQ

[@catfisherboy]

Iwas about ready to throw away my XE pro, until I re calibrated my 'Z' axes
It was plunging into the workspace so far it would stop the machine before I could hit the Emergency----I hads been serching for weeks for a solution. I hope the first thing everyone would do, is check the calibration and all 3 axes, a wored to the wise
thanks for all your great videos

[@PawPawsWorkShop]

If I may ask, how did it out of calibration?

[@ericeinsmann5559]

Very useful! I need to dust off my Proverxl and expand it.. Thanks!

[@PawPawsWorkShop]

Absolutely, dust it off and get carving. But, don’t stop your pen turning.

[@ericeinsmann5559]

@@PawPawsWorkShop I haven't started pen turning yet.. I just got the material to make the new lathe cart..

[@newsfan77]

Would using a larger travel distance, give you more accurate calculation? Say move 500mm

[@PawPawsWorkShop]

Yes the larger the distance the better.

[@asda5303]

I recently watched ur video on how to do this on ur xcarve in Easel, i have a longmill and use Easel but use gsender as my post processor. Will the calbration steps done in easel correct my machine if I use gsender?

[@PawPawsWorkShop]

Yes, the calibration process is the same