EZBOT Octatrack FX Template Overlay installation
HTML-код
- Опубликовано: 13 сен 2024
- Let me know in the comments if you have one of these already or are planning to buy one.
Patreon: / justinjoe
Gumroad: justinjoe.gumr...
Check out my Music & Socials
Instagram: / _justin_joe Linktree: linktr.ee/just...
Soundcloud: / justin_joe
Bandcamp: justinjoe.band...
Traxsource: www.traxsource...
Audius: audius.co/just...
Gear I use and affiliate links:
Octatrack MKII: bit.ly/3lOMikX
Kenton USB MIDI Host: bit.ly/3iA3XLk
OP-1: bit.ly/3scWFAm
Blackbox: bit.ly/37He5f6
Moog Minitaur: bit.ly/Minitaur-1
Sequential Prophet Rev2
Dave Smith TempestAbleton Push 3E-mu Proteus 2000
#octatrack #elektron #ezbot
YES!! So there IS indeed a video on how to do this!! I just took my new sticker out of its cuddly little cylinder, held it up to the trig buttons on my OT, and had a major WTF moment. Due to the placement of the screws, and the fact that the sticker appears too high top to bottom to fit the available space, I wasn't sure what to do. My first thought was "Uh... I'm going to have to remove these 3 screws, and then fold the bottom of the sticker down over the corner?? Can that be right??" After a moment of decision paralysis, I decided to check RUclips for a video, and... lo' and behold, here it is. I see Matthew offset the print on trigger 9 such that it isn't covered by the center screw -- almost as though he planned it that way! Anyway, thanks for putting this up!
So glad it was helpful!
Thanks for making this lovely guide!
And thank you for making such lovely products!
Ezbot mustache
😂