Ted knows his stuff. He is my go to guy when I get stumped. Good dude. Hey Ted lol.. I am stumped. Old ECM on a Goodman obsolete board.. Going to have to use relays. I will probably be calling you. The board is separate board for just the fan 2 16 pin ecm control and the dreaded dip switches.
This was a great video I don't have a single complaint about it I love that you fast forward through the monotonous parts and that you didn't add any music to the whole thing Three thumbs up
You need to buy the blue hand snake with the 1/4" cable and it will work fine. We have been using them for years. The box store sells a more expensive version that can chuck up in a drill and will work as well.
Ted you underestimate yourself!! I think that’s gonna work out good. I’m with you ready for warmer weather
Ted knows his stuff. He is my go to guy when I get stumped. Good dude. Hey Ted lol.. I am stumped. Old ECM on a Goodman obsolete board.. Going to have to use relays. I will probably be calling you. The board is separate board for just the fan 2 16 pin ecm control and the dreaded dip switches.
Love the bench .
This was a great video I don't have a single complaint about it I love that you fast forward through the monotonous parts and that you didn't add any music to the whole thing Three thumbs up
Sweet set up
Awesome Ted!!!!
Great video again. Sir.
A good mechanic mind never sleeps else it gets bored:) Cleaver simplicity to make a better tool and fun to use!
Nice work Ted I think ya got something there that will benefit your need for sure. Bring on The Cloggs!!!
Cowboy, you’re riding off into the sunset with a smile !
Fantastic jury-rig by an ace mechanic 👍👍. Milwaukee take notice!
Good job.👍👍👍👍
👍👍👍I know you would get it done
You need to buy the blue hand snake with the 1/4" cable and it will work fine. We have been using them for years. The box store sells a more expensive version that can chuck up in a drill and will work as well.
Nice fabrication job Ted ... I was always the sharpest tool in our shed but it was a small shed Thx
Seems to fit the need ! After a few uses and some miles on it...time for another review on its performance.
That’s awesome. If it works I’m going to make one.
Hey I learn from your videos. Thanks man, hope you're doing well
Hmmm, if it breaks at the JB weld, braze it together! I thought that's what you might do from the beginning.
MR. T put a small pop rivet in it .
I was getting worried about Steve Lav, but He did a video today. I think it has been about 4 days since He did a video.
put heat shrink over the two pieces that way if the epoxy does break the shim will stay in place
I still say that You Need a Ms Molly to ride in the Truck with You.
I think you wasted your money, never needed anything like that to clear an HVAC drain. Hope he enjoys the gauges. Just my opinion.