Это видео недоступно.
Сожалеем об этом.
Jaguar X-Type Gearbox Fault: Automatic Gear Shift Assembly Removal
HTML-код
- Опубликовано: 3 дек 2019
- Removal of the Automatic J-Gate Floor Shifter due to a "Gearbox Fault" error code on start up.
This assembly is notorious for malfunctioning from wear and breakage of the plastic components resulting in selector positioning error as discussed on Jaguar forums.
The replacement was purchased on Ebay for $150.00
Luved this instruction SO VERY MUCH !! BETTER THAN TOWING MY JAG 80 MILES AWY TO MY MECHANIC.NOT TO MENTION 7 HRS OF LABOR. I BOUGHT MY PART ON EBAY,TOO. $111.00 TOOK 1/2 HOUR TO REPLACE THE NEW USED ONE. AND NOW, HOPEFULLY WILL FIX MY GEAR BOX FAULT. CLEAR AND CONCISE AND UNDERSTANDABLE WORDAG
Did it fix your Gear Box Fault error?
Your video it’s important for me I have problem with the gearbox failure and in this moment I change with your instructions the gearbox and not payment to experts mechanical , thank you by your video for the community Jaguar .
Thank you so much it helped us with our Jaguar S type so helpful .
anna mote: I’m delighted to hear that
Thank you so much I should had looked this up before I let them boot legs experience on my ride
Great Video Man
What type of problem dod i have, that you replaced the shifter?
Nicely done.
Thank you.
I just bought one of these in april. Done a buncha work to it but now that its all done its got the gearbox fault for d4 switch malfunction. Will go into gear if i shift all the way into 2nd then back to drive. Could this be a linkage issue the cable doesnt seem to move much after going into drive.
I see trasmissoon fault light is this the issue fix for that
Great video, what was the issue, was the car not going into reverse? And do you know if it’s the same fix for 05 S-type R?
You ever find a fix?
The car was only going into reverse. No forward gears worked. Once I repaired the shifter, the underlying issue turned out to be a loose shifter cable which I eventually replaced.
@@goodamnesia my 07 x type i just got is having same issue! thank you! will try this before replacing entire transmission!
@@locprincessasmr Don't replace your transmission! The transmission is not the issue. The problem is likely your shifter cable is so loose that it is no longer moving the linkage arm which puts the transmission into the gears you want.
@@djwreckit5282 Once I replace the loose shifter cable. The transmission ran fine. I eventually traded my Jag for a Saab 9-3 with my buddy. He loves the Jag and it's been his daily driver. Good trade all around.
Hi,
Thank you so much. Do you know if this works as well with a 2004 jaguar xj8?
I started having "Gearbox Fault" in the dash evetime i suddenly accelerate, or when I need to change from reverse to gear "quick", then the message comes and it feels like it puts third gear and doesnt change from there. I can tell its 3rd gear because when that happens and I am stopped, it takes and more work for the car to start going forward, alternatively when I am in the highway and that happens, you can feel and see the RPM going higher at faster speeds (50-55 mph) without that much accelerating because is not changing gears.
Once that happens I have to pull over, turn off the car and turn it back on, afterwards the message goes away and the car shift gears. But I have to be driving carefully because I am afraid that will happen again.
I was thinking that maybe the transmission was giving up but this vide made me think it could just be the shifter.
Do you have any other thoughts or ideas on why Gearbox Fault message might come up?
Appreciate your video and thanks in advance for your help. I am not very savvy with cars but I love trying to work on them and learn.
Thank you.
do you feel a jerk coming from the transmission/motor area of the car after you suddenly accelerate?
@@lukeisrazor9321 yeah i believe now the car is slipping the transmission. I’m guessing it’s not the shifter, right ?
I have a 2003 2.5 and it’s popping up gearbox fault but it’s not bring up any codes when I connect it to a computer
What happen
Can you replace that shifter with the newer circle shifter in the 2014 xk?
Sorry buddy but I do not know.
The wire harness to the gearbox will likely differ. I'd attach the 2014 XK wire harness first to see if they fit before dismantling everything. Good Luck!
My mother-in-law has the same car, her car would not go into gear so I took it apart and with out the top trim and support it will go into gear fine. Just want to know if that's the same trouble you were having?
I had three issues: a broken plastic locking mechanism which I JB welded; a disconnected wire which I soldered: and a loose shifter cable which I replaced. It sounds like you have a loose shifter cable since removing the trim temporarily resolves your issue. Eventually that won't work as the cable will continue to have more play and will result in no longer moving the transmission gears via the linkage arm. Read my reply to S B to resolve this.
Hi guys my x type auto goes into drive but not fully. Sometimes it drives forward but sometimes it doesn’t. I’m gonna check the cable. Can someone tell me if I can replace the j gate shifter for the newer facelift gear shifter. Is that possible, any advice would be much appreciated, kind regards
Sounds more like your shifter cable has too much play. The cable can be tightened or replaced (mine was from eBay) if it's too rusty. You already saw the shifter cable's linkage to the gearbox in my video. The shifter cable's linkage to the transmission is located underneath between the front bumper and the driver's side tire under a 4"x8" curved metal splash shield. There are only three hex bolts holding the cover in place. I sold my Jag to my friend so I cannot provide pics until he takes it out this spring. Good Luck!
I not sure I'd replace an older shifter with a newer shifter model as you may open a new can of worms because the newer wire harness may not be compatible.
Dear sir, my 1999 S-type jag does not reverse. The lever can be pushed to reverse but car does not reverse. Can this fix the problem? Please kindly help cos l am going nuts!!!
It's probably a worn shifter cable. On my '06 X-Type it's underneath the car between the bottom firewall to the transmission clutch near the driver's front tire. Try tightening it first so there's no play. If that doesn't work, you may have to replace the entire shifter cable (eBay). As soon as the weather warms up here, I'll post another vid as to how to replace the shifter cable.
Do you think this would be the same repair for a 2003 s type?
Sorry but I have no idea if Jaguar used the same gearbox for both the X-type and the S-type. Apparently, Anna Mote from an earlier post believe they did.
What's wrong with your 03 s type
Hi, my jaguar xtype 3.0 2004 is reporting engine and gear box fault. The revs are so high. When diagnosed it reported the tps, I have changed it but the problem is still there. What can be a reason?
What size torque bit did you use
Sorry Ben. I don't remember as I already sold my X-Type to my friend to buy an XK-8.
I changed it and still have the gearbox fault and hesitation until about 12 mph...any ideas?
Sorry Mark as I'm just a backyard auto DYI'er and you are in territory beyond my knowledge.
Probably need to changed the shift solenoid
My underlying issue turned out to be a worn out shifter cable. Over the years, the cable became loose. Once I replaced the shifter cable(eBay), the jag was working again.
do you have a how to on replacing the shifter cable? is there a way yo determine if it is the cable? Instead of buying the while gearbox?
Take it easy man!
Hey, what was the code you get ?
shaihuld: I did not connect the ECM to an OBD to pull the actual code. My dashboard simply stated “ Gearbox Fault” so my research led me to the shifter as the most likely problem. Once rebuilt, the car ran smoothly again.
shaihul
My jag gives gearbox fault while shifting in 3-4 did u had same problem?
Updates?
After this video, I was able to drive it around town without any issues. Over the next several months, I was not able to shift the gearbox back into park as easily. Moving the shifter into drive, neutral and reverse, was no problem but getting it into park was not happening. I could only park it in neutral on a flat surface and had to place chucks on the tires. The Pandemic came and I got busy at work (hospital) so I put the car away. I finally got caught up and I discovered the issue was the shifter cable was worn so I replaced it. I'll post how that's done once the weather warms up here.
What code/check engine light did you get
He said it was "Gearbox Fault" multiple times
The automatic transmission shifter is rebuildable
how
@@tightwrite85 google it
I searched for this because my Jaguar xj8 is saying gear box fault.
What was the error code you got for this fault?
He said it was "Gearbox Fault" multiple times
He did?😂😂😂
@Tom "Gearbox fault" is not a code, that's the description of the code 🤨
I’m Roman’s friend
Welcome to my channel. Roman is the coolest dude I know.
you need to remove the tools off the seat wtf man no respect for the interior hope this was your car !
You're absolutely right and this is my car.
Wwwwwww