2014 Audi A4 driver side CV axle replacement
HTML-код
- Опубликовано: 12 сен 2024
- In my opinion, replacing CV Axles on these models, is one of the easiest things in the world. Just watch and you will see.
This is a great repair for DIYers so for those of you wanting to tackle this job, I have linked all the tools that you will need down below:
Impact gun: amzn.to/48pSZzV
Impact gun batteries: amzn.to/44VT1ww
Hook/Pick set: amzn.to/3EK7Sj4
Sleeved Impact socket set: amzn.to/3RvjgqH
WD-40: amzn.to/455MWh0
Hex socket set: amzn.to/46lCLGo
Triple square socket set: amzn.to/3Pv9eDn
3/8 locking extension set: amzn.to/3LwxOT9
Brake caliper grease: amzn.to/48lWMhJ
Blue Loctite: amzn.to/3roBSxL
European wheel guide set: amzn.to/3LyxC5B
Torque stick set: amzn.to/3PMi8gP
#Audi #A4 #mechanic #automotive #european #euro #tools
By purchasing products through the provided links, I am awarded a small commission on qualifying items at no additional cost to you. Your support is greatly appreciated!!
*Disclaimer: Due to circumstances beyond the power of Chilli's Automotive, I am unable to guarantee proper use of the information shared. Chilli's Automotive assumes no liability for injury or damage to property inflicted as a result of any information contained in this video. Information received from this video is to be used at your own risk. The use of safe practices and precautions are recommended by Chilli's Automotive while performing a repair of any sort using any category of tools that have been seen in this video. No information held in this video will produce any expressed or implied assurance or warranty of any certain result. Any damage, loss, or injury that may result from improper use of equipment, tools or information seen in this video is the the exclusive responsibility of the user and not Chilli's Automotive.
Looks pretty easy!
Cual era la falla la espiga de caja o ña omocinetica
Really nice and clear video! What kind of grease did you put on the new cv axle ?
I used brake caliper grease. I have the stuff I used linked in the description. You can also use anti seize
@@ChillisAutomotive thx for replying !
I noticed that my Audi b8 axle is also worn and the transmission is slipping. Might the Cv joint axle be the cause of that? Please assist 🙏🏼
I personally have never heard of a case where the cv axle caused a transmission to slip. However that doesn't mean it's not possible. The most likely reason for a transmission slipping is by low fluid level in the trans, or burned/worn clutch packs.
What size bit is that for the 6 bolts at the top of the axle?
M10 triple square
@@ChillisAutomotive thanks for the quick reply!
And do you know what torque i need to use for the main hex bolt?
@@zachschuler1222 200 nm (147 ft lbs) plus an additional 180 degrees. It's best to torque the bolt with the wheel on the car and sitting on the ground so it won't spin while you torque it. For some reason I didn't show the specs or the process in the video, In the future I will most likely make a revised video doing so the next time I replace one.
What is the size for the main hex bolt?
17mm hex
On my 2012 S4, the original axle hub bolt was a 19mm, My new GKN bolt is 17mm! Wtf!