2:56 Power button cable has a connector which does come off from PCB just by pushing with a screwdriver. And then you can see and get access to the plastic latch which holds the power button.
@@proexservis thanks for reply. Just one more please, which model would you choose, this one or bgls4pow2. Actually, i prefer more bgls4pow2 because it doesnt have that remote power on the handle but i really want to know your opinion. Thanks
Hi, how to disconnect IR? I try do it from the inne side but I'm affraid that I will break the cable. I can't take the llastic button which helds the IR sensor
Hi, you have only 2 options, 1: pry out plastic cover (button) and disconnect IR or 2: pull up whole rear cover with circuit board like I did it. Any cable can be repaired, dont be afraid to pull it little harder 👍
2:56 Power button cable has a connector which does come off from PCB just by pushing with a screwdriver. And then you can see and get access to the plastic latch which holds the power button.
There is no information about disassembling of IR-sensor base in this video (2:50-2:55). It’s very important for me - I stuck with this problem. 2:50
From the bottom of top cover there are plastic latches which hold IR sensor holder, you have to unlock it from bottom to pull it out from top side
Hello, is this common probeln on the series 6. Is it maybe better to buy serie 4, like bgls4pow2 instead of this?
Hello, no, it is not common problem, just dont step on plastic on/off button and it will be fine for years. 👌
@@proexservis thanks for reply. Just one more please, which model would you choose, this one or bgls4pow2. Actually, i prefer more bgls4pow2 because it doesnt have that remote power on the handle but i really want to know your opinion. Thanks
@@Biodrone1556 i would choose without control handle too, control handle vacuums are more expensive and one more problem if it get damaged.
@@proexservis thank you once again for reply. You just verified everything that i suspected about difference over those two models.
Anyone can help with the disassembly of the Bosch Series 4 Vaccum? The automatic cord rewind button is broken
Hi, which model? (E-Nr)
Hi, how to disconnect IR? I try do it from the inne side but I'm affraid that I will break the cable. I can't take the llastic button which helds the IR sensor
Hi, you have only 2 options, 1: pry out plastic cover (button) and disconnect IR or 2: pull up whole rear cover with circuit board like I did it.
Any cable can be repaired, dont be afraid to pull it little harder 👍
I got it! :) thank you!
mine does not stay on when pushed was it the same problem?
@@tonypasma1707 probably you have bad, faulty on/off button (switch)
@@proexservis how do i take out the plastic button