Ford F-150 - RADIO REMOVAL / REPLACEMENT (2004-2008)

Video on how to replace / remove / install or upgrade factory stereo on Ford F150 truck ( 2004 | 2005 | 2006 | 2007 | 2008 | XL | XLT | LARIAT | 5.4 | SUPERCREW | CREW CAB | EXTENDED CAB | REGULAR CAB ).
Replacing factory radio on Ford F-150 is very easy and straightforward. First pop out plastic trim piece that is surrounding the radio. Then unplug the airbag wire (make sure to disconnect battery before you do so). Now you have access to the radio. Unscrew four 7mm screws which are holding the stereo in place. Pull out the radio and disconnect radio antenna and 2 plugs from the back side. That's it. Watch the video for the step-by-step guide.
Thanks for watching.
Don't forget to Like the video / SUBSCRIBE to the channel!
⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@frankdelucey2137]

You will also need a pair of needle nose pliers and a flat screwdriver because the metal clips will usually stay in the dash and not on the trim piece.

[@destinglisson3145]

Thanks for the idea of tape on the paint scraper for a trim tool!

[@QuiteAlright]

No worries :)

[@RobertWilliams-wx5ui]

Good information about the kit and harness. Thanks

[@QuiteAlright]

Glad it was helpful!

[@nehemiahmathews8683]

I think you did a very good job at the narration and the synced manner in which you did things you kept all the pertinent information in line and in the video thank you very much you are more than helpful and that 50 to $100 can you believe those scumbags.
Sons of guns I bet you that's why the one that's in my truck now doesn't work because it was put in there it was replacement and they didn't get that code very important thank you again

[@QuiteAlright]

Thank you for watching and for the comment. I'm glad you found my video helpful

[@ayyvictor4629]

I put a replacement stereo in my truck today and notice it worked fine, the only difference with the two was the new stereo didn’t have “mp3” written on it the old one did, my battery died after 5 minutes of setting up which is a known issue and I think the battery is getting old , explain more about the codes

[@VicfromOregon]

Thank you! Very, very helpful!

[@QuiteAlright]

You are welcome

[@shaneupton1656]

Good camera work!

[@QuiteAlright]

Thanks!

[@HELIARCMASTER]

Thank you. Your video was simple and to the point. Great info

[@QuiteAlright]

Glad you enjoyed it!

[@noecampos1359]

Very good recomendecions. Gracias amigo 😅

[@QuiteAlright]

You're very welcome :)

[@mr.turtle6110]

Im tryna put in an after market radio(JVC kw-580BT) in my 08 f150. Have no clue what that smaller plug is(not the attenna) to find a harness adapter for said radio

[@davidcampos7243]

Thank you for this video

[@QuiteAlright]

My pleasure

[@DavidHitt-fg4cx]

Thank you! When putting the bezel back on, do you install the metal clips on the bezel first and then press in the bezel, or do you leave the metal clips in place and press the tabs of the bezel into them? Thanks in advance.

[@QuiteAlright]

You're welcome. It was quite a while since I recorded this video but I believe you should just leave the metal clips in place and press the tabs on the bezel into them

[@InaMopar]

How did you do it the bottom of mine won’t go back on the top and sides go fine but the bottom pushes in but comes out 😭

[@DavidHitt-fg4cx]

@@InaMopar The same thing happened to me. The only way I could get the bezel back on was to pull out all the metal clips, mount them on the bezel, then carefully align the bezel and push it in place.

[@aarongray7364]

Same install if the truck has a factory subwoofer and amplifier? Thanks
Great vid!

[@QuiteAlright]

Hi, should be the same but you might have more connectors to disconnect behind the radio unit

[@donaldlloyd6463]

What does the small electrical connector do at coming into the rear of the radio?

[@mr.turtle6110]

Thats the attenna

[@Jetzzz82]

Thx!!! Very nice!

[@QuiteAlright]

No problem. Thanks for watching

[@usmajuan]

Nice! Vey helpful!! Like!

[@QuiteAlright]

Thank you! Cheers!

[@billym7503]

I took it out and put it back in now my truck wont turn over

[@carstuff4u942]

Reattach the battery leads

[@williamriley2528]

Plastic BEZEL...!

[@PennyJackson-te3ju]

05