Audi R8 Maxton Design Front Splitter Lip Install
HTML-код
- Опубликовано: 12 дек 2020
- Watch in 4k!
How to install a Maxton Design Front Splitter Lip Spoiler Installation
Buy the Splitter From Amazon or Ebay
amzn.to/3QEUqkk
amzn.to/2PpK0eu
ebay.us/Qz3nqn 
Авто/Мото
Looks good thanks for those instructions.
Looks factory...looking at options but I like the type that come up on the ends. Thanks for sharing!
Looks fantastic 👍
nice job I have done 2 of their splitters on Teslas. Only difference is I put polyurethane sealant to stop any slow dirt ingress.
What screw size did you use?
Great video.. If I drop the belly panel in the front, Is there access to install nut and bolt fasteners instead of the self tapping screws? The self tapping screws are just going into plastic , correct? Thanks...
yes and yes.
@@DuhRaceCar ..... You cant get in there...
Use rivnuts or rubber well nuts.
Looking forward to this build tbh
I actually got quite a few videos I need to edit and post up
@@DuhRaceCar looking forward to them 💪🏻💪🏻
Don't the directions call for you to use bolts all the way across rather than self tapping screws? I just got one of these for my S6 and I literally have to remove the front bumper to get it installed properly.
Mine didn’t come with bolts. Just double sided tape and the factory holes. I bought the self tapping screws myself to be safe.
Would love to see some updates on this, when and if possible.
What do you want to see?
@@DuhRaceCar looking to see how your install holds up to some good stress tests.
Do you have definite plans for certain mods / updates?
@@jschrauwen have gone 110 mph + no problems. I had read some people had issues that didn’t use the self tapping screws, but none that had. Granted there were some people fine with just double sided tape but I was being cautious. I got a lowering video I need to edit and post up but it’s long.
@@DuhRaceCar I just picked up the splitter today from Maxton.ca .
How that spoiler holding up?
Been fine for 2k miles. High speeds ect