How to program OEM steering wheel control on a JVC Kenwood Multimedia receiver
HTML-код
- Опубликовано: 8 авг 2018
- how to program the OEM steering wheel controls to a Aftermarket Multimedia receiver
Please check our online store for any products that can help you with your installations.
www.mavs.com.au 
Авто/Мото
Thank God for this video, I wasn't holding the button's down to program them. Which is obviously the key thing to do here
Thanks for putting up this video - I just set the steering controls to my JVC head unit. There were no instructions in the manual - this video was great. Thanks again.
No worries thanks if you can subscribe and like that would be greatly appreciated
Thanks for your effort and time. What about the steering wheel phone buttons? Are they supported?
To be honest I can't recall if they do or don't but in some cases those are optional so it's not part of the main wiring harness and therefore cannot be integrated as the swc only has a ground and 2 input
I have the KW-V830BT had it installed at best buy. on my vw the microphone button is set to lower volume i want to change it to voice control how do i find it on my unit? the other controls are correct.
Did you install it with the OEM steering wheel control wire or did you get the swc harness? If the harness then you can't change it, but if it's the wire then go to your setting and change it through there.
Hi, I just replaced my old stereo in honda civic with a kenwood from Nissan Navara ddx7015bt. However, I cannot program the remote. Even after we reset the settings, the button seems already programmed. Do you know how to reset?
When you're in the steering wheel controls programming mode press initialise
mate do we need to learn steering control only on after market stereo, or factory one as well ??
Just only after market units
thanks mate for prompt response
Hi there. Do you have a video for the wirings?
No sorry I don't but if you email me at I can send you a picture of wiring
Admin@mavs.com.au
I’m mailing you for this. TIA!
Hi,
You know how the jvc has 1steering control wire from the unit, and 3 on the jack remote input, where do you connect the 1from the unit to?
Advice please!!
Hi if you're using a ISO Harness with a swc then you would use that single wire but if you're going to program it yourself without the iso harness then you use the 3.5mm with the 3 wire input
@@mavsonline my stereo is similar to the one in your video, and i was gna use the same process to program it, I just need to know where to hook up the one wire from the stereo or do i just use the jack input with the 3 wires!
Are you saying that I don’t need to use that one wire if i use the 3wires on jack input?
Yes only use one or the other not both
Cool thank you, il give it a go
Cheers
friend I want to buy some Bluetooth steering wheel controls for a radio JVC Kw-m855bw but the Steering Remote Control Setting option does not appear in the menu, you can help me. Thanks.
Just make sure that tha parking brake wire is grounded or you cannot access that part of the menu
Did you use a steering wheel control adaptor like a pac swirc ?
Hi no these new JVC And Kenwood unit has a built-in OEM Steering wheel control integration wire which can be programmed to most vehicles so no need for after market adaptors
@@maverick180 it that a jvc kwv320bt?
It's the JVC KW-V340BT
But the 320 can be done the same way too
@@maverick180 I do see the 320 being sold online with the PAC swirc so I purchased it as well haven't installed it as yet
Where you based
Rutherford Paniora hi we are in maidstone Victoria mavs.com.au
Maidstone 3012