How to Replace Driver's Side CV Axle 2012-2017 Toyota Camry

Поделиться
HTML-код
  • Опубликовано: 21 окт 2024
  • Buy Now!
    New CV Axle Assembly from 1AAuto.com 1aau.to/ia/1AAC...
    This video shows you how to install a new drivers side CV axle in your 2012-2017 Toyota Camry. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.
    This repair was done on a 2014 Toyota Camry SE 2.5L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
    2012 Toyota Camry
    2013 Toyota Camry
    2014 Toyota Camry
    2015 Toyota Camry
    2016 Toyota Camry
    2017 Toyota Camry
    🔧 List of tools used:
    • Pry Bar 1aau.to/o8B/1AX...
    • 17mm Socket 1aau.to/ob6o/1A...
    • 21mm Socket
    • 30mm 12-Point Socket 1aau.to/oau/1AA...
    • 1/2 Inch Impact Gun 1aau.to/oyo/1AX...
    • 1/2 Inch Breaker Bar 1aau.to/orN/1AX...
    • Torque Wrench 1aau.to/obap/1A...
    • Anti-Seize Grease
    • Gloves 1aau.to/oa3H/1A...
    • Safety Glasses
    • Floor Jack 1aau.to/oawB/1A...
    • Hammer
    • Jack Stands 1aau.to/oaiC/1A...
    • Rubber Mallet
    Subscribe: / @1aauto
    For More Info visit us at 1aau.to/h/fWi/
    ⚠ DISCLAIMER:
    While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Комментарии • 19

  • @1AAuto
    @1AAuto  6 месяцев назад +1

    √ Watch the Video
    √ Buy The Part at 1A Auto 1aau.to/m/Visit-1AAuto
    √ Do it Yourself
    √ Save Money

  • @IOSALive
    @IOSALive 6 месяцев назад +2

    1A Auto: Repair Tips & Secrets Only Mechanics Know, This made me laugh so hard, thanks for sharing!

  • @johng.4959
    @johng.4959 6 месяцев назад +5

    Keep in-mind, many CV Axle manufactures do NOT advise using anti-seize on the splines. I understand the concept, but there is a reason they do no want this added to such tight tolerances.

  • @a.j.4163
    @a.j.4163 3 месяца назад

    The best channel in the world for teaching how you can do it by yourself

  • @Ullikummi86
    @Ullikummi86 3 месяца назад +2

    CV Axle cameout like butter... good editing.

  • @legacy90
    @legacy90 19 дней назад

    I just have one question: where do you find that sensor?

  • @azee805
    @azee805 6 месяцев назад +1

    Can this be done the same process on the right side?

    • @1AAuto
      @1AAuto  6 месяцев назад +1

      +@azee805 We don't have a how-to video for the passenger side right now, but the basic steps in this video should be enough to do this task. Buy this part for your vehicle on 1AAuto.com: 1aau.to/m/Shop-1AAuto-c

  • @Xainlrd
    @Xainlrd 4 месяца назад +1

    I’m amazed on how easy you were able to remove the cv axle from the transmission…how?!?

  • @hugrule3970
    @hugrule3970 Месяц назад +1

    I have done this on a Rav 4 with the same transmission. It is not this easy. It’s hard to get a pry bar in there because it’s recessed in the transmission. Even if you can, it’s likely the snap ring is going to resist you. I used a slide hammer and after turning the wheel a 1/4 turn on the other side each time I pulled on it, finally it came out. If you are doing this job, I would definitely replace the axle seal which sits flush on the transmission as there is a good chance it will be damaged when you pull the old axle out. Also USE OEM axle and seal. The first time I tried AutoZone and it lasted 500 miles and sounded like clanking noises on turns. All that aftermarket stuff is made in China and it’s not worth the risk as I found out the hard way.

  • @edwardmarquez7452
    @edwardmarquez7452 4 месяца назад

    Got this done thankyou very much

  • @maxxiidabeast1080
    @maxxiidabeast1080 22 дня назад

    Is it the same for 2015 Scion tc?

  • @Mathematiman
    @Mathematiman 5 месяцев назад +1

    I had a shop tell me they wanted to replace both my cv axels after I had brought my car to them for a completely different issue. They wanted to charge me $1300 for the job. I declined, and I'm glad I did. From what I'm seeing here, they were charging way too many hours.

  • @ishfakuzzamanchoudhury161
    @ishfakuzzamanchoudhury161 4 месяца назад

    I have 2017 se camry cv axel broke which brand you recommend for me from out market ?

  • @lovelyaj4369
    @lovelyaj4369 2 месяца назад

    Good job

  • @melvinchamberlin823
    @melvinchamberlin823 6 месяцев назад

    Sir I got a 2013 ram 1500 is 4.7 l in it I want to know how it comes with orange antifreeze in it I want put green press tone and it would that hurt that motor or that radiator or the heater core please let me know appreciate it thank you let me know have a good day

  • @jamesrichardson771
    @jamesrichardson771 6 месяцев назад

    Very Nice💥🛠

  • @TwoScoops76
    @TwoScoops76 3 месяца назад

    🏎️🔥🔥🔥good learnings

  • @hakyongkim4111
    @hakyongkim4111 6 месяцев назад

    ⁰ㅔ 좋은데