Bentley Contiental GT air strut replacement & calibration

Failed air strut replacement in Bentley Continental GT 2007. Same as Flying spur, Volkswagen Phaeton.
Air strut replacements are from RMT. also consider doing your Halfshafts while you have it apart as they may be shot too. I was able to hear a cyclical vibration/grinding especially under low speed braking when mine were bad.
Suspension Computer login - 31564
Ch1, left front. 2- Right front, 3- left rear, 4- right rear, 5- save a value of "1" to save all values. Have to start on ch1, and assign a new value, even if assigning the default 395, or it will block you from access after Ch 1 and you'll have to start over.
Check out Ross Tech for recalibration. System diagrams from Phaeton available in the comments.
Another good guide here- • Bentley Continental GT...

[@rcmakingtracks18]

Very helpful info. Thanks for sharing. John

[@Klast94]

@sdalin27 for the calibration part what do you do after you input all 5 values? autel gives you the option for a 6th value. Do you just exit after the 5th value of 1?

[@sdalin27]

After I saved the fifth value the car went into action leveling and correcting ride height. It also cleared jack mode. I didn’t do anything with value 6. If it doesn’t work start at the beginning again. You can’t skip ahead and have to go 1-4 then 5. I had to re do it a bunch of times before it held the signal and everything was input correct. Part of that was not knowing I needed to save a fifth value though too

[@Klast94]

@sdalin27 do you recall if the vehicle was turned on or in accessory mode? I was able to get into the values and input them once but now it keeps telling me me signal is out of range and doesn’t let me back in to input values. (was doing this before i was able to get in the 1 and only time)

[@sdalin27]

@@Klast94 I think it was running and not in accessory mode. Don't remember for sure but I had that issue too wit the computer going to sleep

[@sdalin27]

Ross tech calibration guide. Works with VAG tool or Autel scanner. www.ross-tech.com/vag-com/cars/levelcontrol.html.

[@sdalin27]

Phaeton system diagrams (Same as Bentley) drive.google.com/drive/folders/13zHVHuPWdpZqgPQwkxW3qEDMmdGNd6_f?usp=sharing