Instillation of ID Backscenes

Adding back scenes to Makerfield South
ID Backscenes add an extra dimension to the scenic areas of the layout
This video shows you how and gives you a little insight into the layout itself
Shot in summer 2020, more to come soon !!

[@Julian-zc4ik]

Looking forward to following you on your journey - enjoy! All the best, Julian

[@ashpitcher3]

That looks great mate. Thanks for the install video, about to start mine so your tips were appreciated.

[@Chris-BognorRegis]

You made it look so easy. I had a go last night, got it down and it looked great when it was laying flat on the worktop.
It was only when I stood it up that I could hundreds of bubbles, which I thought I had smoothed out when I was laying it in the first place.
Now mine is on a large radius bend and I did ask the makers how I should go about it. They said lay it flat, should be no problems when you bend it. Well when I bent it loads of creases appeared which you can quite easily see on the sky sections.
I found that as it had an adhesive back I had no wiggle room whatsoever, it was exceedingly sticky and when it stuck it stuck, had the devil of a job lifting it off the board and relaying it.
Yes I took my time, yes I used a rag and smoothed everything out to no avail and yes the backing board is a upvc board which is more than adequate according to the backscene supplier. So where have I gone wrong I ask?
Next time I am going to leave the backing on and use an adhesive so that I get some wriggle room and see how it goes.
How do your backscenes look now that they are upright?
Regards Chris

[@johnbirks258]

Looking good mate. I started clearing the loft last week to make a start on mine

[@Steamplug]

John best move I ever made, nobody ever goes up there so everything is as I left it when I come down.

[@HornManish]

'Instillation' - Installation - typo?