What Happens When You Push A Bendpak Lift To The Max???

[@DMAXRYNO]

I’ll bring over the f450 so we can max out the width.

[@TheOne-yc1wt]

We know the true test is the mini truck

[@JColip1776]

I want to see this cause I have a 450 and looking for lift!!!!!

[@EddieLife3500]

Shit I’m down let’s do it

[@6xflowerranch890]

I have used them for years. I’ve only had one time when it failed. One side got stuck and started going down and the other didn’t. It locked and wouldn’t go up or down. We had to pry it up to release the lock then went all the way up until it stopped and then went down perfect . Good choice. 👍🏽

[@warrenmullett]

I wouldn’t bolt it part of the benefit of a 4 post.. does seem a little sketch lifting the rammer but I agree it’s all rated for more than listed … 😅

[@FreedomIsntFree2023]

Regarding the anchoring of the lift, I would follow whatever Bendpak recommends. If you do end up bolting down, I would be leery of anchoring into an expansion joint. My 4 post lift mfg requires it be bolted, but it is a 12,000 lb lift.

[@aham3476]

Nice set up!

[@Tdaz250]

Need an updated garage tour

[@JoshMaynard-fm8qh]

I like a 4 post lift but my preference is a 2 post lift. But that's just me though there all nice to have an use.

[@jefflaib2135]

Would love a lift in my garage but don’t I have enough overhead clearance. What would the recommended clearance be.the tallest I have is a stock Suburban but I am looking to a 2500 Silverado but again I would leave it stock height

[@cp_atving5084]

Can you drive on and off either end of the lift or is there a front and back to the lift?

[@kjohns236]

Dialed!

[@brandonmiles9410]

First here