My Chinese mini won’t load on a trailer, as soon as I start going up the ramp and get it at a slope. It stops moving. The tracks and the bucket and arm just stop. Is that a safety feature or do you have any ideas? I can’t find anything on the internet about that problem. All my fluids are good
Do you know if anyone has put this on a AGT 18 yet? This is prob a dumb question as I didnt learn the answer yet, does it matter which side the variable flow control valves are mounted on? Ty Sir.
You seem to know alot about these chinese excavators, I bought a 1.8 ton typhon with the kabota diesel. It has pilot controls an the hydraulics runs to motor radiator for cooling. My motor doesn't show hot on temp gauge, but my hydraulic is coming out holes in under fill cap on hydraulic tank an tank feels very hot . It's not over filled , do you have any idea what's causing this?
Just bought em before watching this video. Thanks for you service Cam. I try to comment on every video. Stay safe.
What does the cushion valve help prevent/ do
Will you have these back in stock soon?
Does anybody have the hose fittings part numbers?
hello Cam... what do you think of using on Orifice restriction fitting on some of the controls like the boom.
I would note this kit also works on an ff12 and ff13
Currently confused as to why there are 4 new hoses for the kit.
I thought the video you did with the cushion valve install only used 2 new hoses
Oh I think I got it now. You are putting the other two at end of a pair to extend one side of hoses to valve
My Chinese mini won’t load on a trailer, as soon as I start going up the ramp and get it at a slope. It stops moving. The tracks and the bucket and arm just stop. Is that a safety feature or do you have any ideas? I can’t find anything on the internet about that problem. All my fluids are good
Could your reservoir hoses be swapped and it's not getting Hydraulic Fluid supply like it needs?
There is a propertioning valve on the hydraulic block. Has a little allen wrench with a set nut that adjusts flow. Screw in created more pressure
Do you know if anyone has put this on a AGT 18 yet?
This is prob a dumb question as I didnt learn the answer yet, does it matter which side the variable flow control valves are mounted on?
Ty Sir.
I assume extension side would be the most logical?
You seem to know alot about these chinese excavators, I bought a 1.8 ton typhon with the kabota diesel. It has pilot controls an the hydraulics runs to motor radiator for cooling. My motor doesn't show hot on temp gauge, but my hydraulic is coming out holes in under fill cap on hydraulic tank an tank feels very hot . It's not over filled , do you have any idea what's causing this?
M16x1.5? The nut on my swivel lines into the valve block seems to take a 19mm wrench
Never seen one take an m16 fitting, only m14’s on 1/4” lines
@@thegarageconnectionmostly 5/16” lines on mine. Thanks for your informative content
I went to buy your cushion valve kit but it says it's out of stock Am I doing something wrong on my end?
Never mind. Video answers question. Safe travels downrange.