I did the same thing and my dead center lines were not lining up either. I adjusted manually to line up the lines but pin hole on the back intake cam is slight off like a few mm. You could still see the hole but it’s not perfectly aligned. Have you install the engine? Any issues because of that?
I did the same thing and my dead center lines were not lining up either. I adjusted manually to line up the lines but pin hole on the back intake cam is slight off like a few mm. You could still see the hole but it’s not perfectly aligned. Have you install the engine? Any issues because of that?
I would make sure they're all aligned, i had to move the vtc gear a bit (After I torqued it) and it ran perfect
Do you know what degree the 9th gen Si VTC goes up to ?
I believe 25 or 35 degrees