really like this, one small issue i noticed was this the tire marks, the streaks should actually run to the left of the tire mark, they're produced due to the car dragging the tire against the wall AFTER the impact, the solid circles are produced during the first contact with the wall, streaks thereafter. otherwise, phenomenal work!
Nice work at that diorama and I love the way you made the Daytona logo in the safer barrier. Can you explain to me how do you made the Daytona logo in the safer barrier so I can take notes, please?
Hi, thanks. The safer barrier is made from 1/8th particle board bent 90degrees to stay upright with the road as it twists. Once that is solid the inside of the barrier and wall were just made from balsa wood. You don't see it tho, however they are shaped as the real ones. The logo on wall was done with a vinyl cutter used as a mask then airbrushed on. I should of just used the other side and applied them as a sticker so to speak. Masking and airbrushing resulted in an error when removing the mask and thats why the one section looks like a "wall scrape". Only the one "A" was messed up.
![Ice On My Teeth - ATEEZ エイティーズ 에이티즈 [Music Bank] | KBS WORLD TV 241115](http://i.ytimg.com/vi/c-n92OgbbwA/mqdefault.jpg)
really like this, one small issue i noticed was this the tire marks, the streaks should actually run to the left of the tire mark, they're produced due to the car dragging the tire against the wall AFTER the impact, the solid circles are produced during the first contact with the wall, streaks thereafter. otherwise, phenomenal work!
Wow what an amazing diorama man I am totally impressed thanks for sharing!!!
Very nice diorama looks great
Very cool diorama. They look so real when you get done. Ron
That they do, it also helps out with photoshoots! Thanks again Ron!
Love the fence. Cool video ✌️😎x 100 likes
Wicked
Fantastic. About how long did it take you to do this?
Fine line tape will minimize rough edge
Nice work at that diorama and I love the way you made the Daytona logo in the safer barrier.
Can you explain to me how do you made the Daytona logo in the safer barrier so I can take notes, please?
Hi, thanks. The safer barrier is made from 1/8th particle board bent 90degrees to stay upright with the road as it twists. Once that is solid the inside of the barrier and wall were just made from balsa wood. You don't see it tho, however they are shaped as the real ones. The logo on wall was done with a vinyl cutter used as a mask then airbrushed on. I should of just used the other side and applied them as a sticker so to speak. Masking and airbrushing resulted in an error when removing the mask and thats why the one section looks like a "wall scrape". Only the one "A" was messed up.
@@surerockco.models3452 Hi, you're welcome! Thanks for replying!
Wish I cod buy this
Nnnniiiicccceee
Can't hear you over the music.
Sorry, I have a deep voice. I must invest into a microphone.
"Don't spend alot of time on the diorama " ? Bad advice. If your going to do a diorama, do the best you can.