Thanks for sharing this! I watched your video many times before tackling it myself. Just did this pump replacement on my Can-Am Ryker today. I followed the steps as you described and it worked out perfectly. I have a couple of complaints about the new pump kit though, the pressure regulator had a broken screen of some sort so I had to use the old one. The solder joints on the new motor terminals were really poor. I ended up removing the leads and soldering the new motor to the old wires. I think next time I will just by the whole assembly since it's only $70 more and would save a lot of hassle. On step I added to mine was to depressurize the fuel system by disconnecting the fuel pump electrical connector then running the engine until it dies (about 5 seconds). This helped clear out fuel in the lines. Thanks again for posting this video 🙂
I have a 2017 can am outlander 450 4wheeler and it sat for two years now it wont run. Put a new plug in and it ran but wont get over 39mph and is backfiring really bad. Could it be dirty injectors bad fuel pump dirty fuel filter?
Which color wires or for what on the plug if you don't mind? I'm trying to troubleshoot my 15 450L, the pump won't come on wanted to check make sure it was getting power before I just replace the pump. I checked the purple/black right next to the black wire and it gets power for a second when turning on key but they power comes off of it.
Thanks for sharing this! I watched your video many times before tackling it myself. Just did this pump replacement on my Can-Am Ryker today. I followed the steps as you described and it worked out perfectly. I have a couple of complaints about the new pump kit though, the pressure regulator had a broken screen of some sort so I had to use the old one. The solder joints on the new motor terminals were really poor. I ended up removing the leads and soldering the new motor to the old wires. I think next time I will just by the whole assembly since it's only $70 more and would save a lot of hassle. On step I added to mine was to depressurize the fuel system by disconnecting the fuel pump electrical connector then running the engine until it dies (about 5 seconds). This helped clear out fuel in the lines. Thanks again for posting this video 🙂
Thanks for sharing, good vid. Had the same issue. Wish I found this video earlier! :)
Thanks and Thanks for watching.
Great video. I saw after I diagnosed and disassembled mine. I did splice and heat shrink wiring. Didn't change relief valve.
video looking crisp!
I have a 2017 can am outlander 450 4wheeler and it sat for two years now it wont run. Put a new plug in and it ran but wont get over 39mph and is backfiring really bad. Could it be dirty injectors bad fuel pump dirty fuel filter?
How did you check the pressure?
Merry Christmas!! Bud, love your videos!! I’ve learned a lot from you!! Thanks for sharing the knowledge!!
Thanks man Merry Christmas to you too and thanks for watching
@@FourwheelerDoctor your welcome, keep them coming!
Which color wires or for what on the plug if you don't mind? I'm trying to troubleshoot my 15 450L, the pump won't come on wanted to check make sure it was getting power before I just replace the pump. I checked the purple/black right next to the black wire and it gets power for a second when turning on key but they power comes off of it.
How long did that pump hold up? What brand?
What was the pressure before and after replacing the pump?
Merry Christmas! So much fun stuff in your shop!
Fun to ride.. not so fun to work on sometimes. Lol
My 2016 450 outlander starts & stays running until I gas it cuts off could it be the this same reason
I have seen the injectors cause that before but it could be the pump as well.
Merry christmas four weler
Merry Christmas to you too!!
My 2017 canam outlander 450 the fuel won't go down when i fill it i know its not full
Yeah. Supposed to be 50 psi. Replaced mine 2 weeks ago it was at 30 psi
Legend
I have a 2018 570 it starts but as soon as you give gas it backfires through the intake, could that be fuel pump?
Probably fouled plug. Bad fuel pump will cause it to die
I've seen other videos describing and showing what you said and they all say it's the fuel pump... did you get it figured out??
The only good replacement besides the OEM one is the quantum pump , otherwise you’ll have more issues constantly
I have a can am 450 cranks but wont start is it the fuel pump as well
Do you hear the pump buzzing when you switch the key on?
@@FourwheelerDoctor yes
@@FourwheelerDoctor i had it just sitting there didnt use it for a while
Do you have the kit part number that you order ?
Thanks!!!!!
Amazon.... 90 bucks or so.
Ace new video the honda rencon clush replasament
Merry christmas four weler closhes sentrifugos
Merry Christmas to you too
@@FourwheelerDoctor Ace new video the honda rencon clush sentrifugo replasament