P0741: TCC SOLENOID PERFORMANCE OR STUCK OFF 4L60E (PART 1)
HTML-код
- Опубликовано: 28 авг 2024
- Using the scantool I watch the tcc slip speed on a malfunctioning transmission. Then I watch the tcc slip speed on a good/fixed transmission. The problem that caused this code was that metal had stuck the TCC valve in the open condition. A rebuilt transmission with a rebuilt valve body solved this problem.
If you guys are having solenoid problems inside the transmission on the 3800 and couldn't remove the side pan due to rusted out subframe or something else what I did was cut the brown wire on the transmission harness was about to junk the car but now that I cut it the torque converter is working again and shifting every gear I put 400 miles in 3 days no problem at all
Will this work on a 2010 silverado 60e trans? 2wd
So did you replace valve body or the harness with the solenoid?
Good explanation
I have a 2001 maxima , 203k miles
Check engine light p0744
Shifting badly
I did a ATF drain and fill adding Lucus
Old fluid was black/brown no metal shavings or metallic tint, no burnt smell either.
After the atf service. it was a lot better, maybe 65% better. I also cleared the code. 70 miles later it came back. At 330 miles it was 80% better now at 600+miles it’s say about 90% better. I have a feeling the TCC solenoid was dirty from the old fluid. If it does not get better soon. It may mean replacing shift solenoids
Transmission : RE4F04A
Nissan Part No.: 31940-80X25
SOLENOID REPAIR KIT - CONTROL VALVE
About. $77-120 part
Well, when a vehicle comes into the shop with that many miles, I rebuild or change the transmission with a unit with lower miles. I never recommend additives to fix the problem because once it is put into the transmission, all the seals will have to be replaced that has been touched with the additive.
THIS IS YOUR TRANSMISSION I understand your thoughts, however given the age of the call and miles and how much it is , fixing the transmission that way would cost more than the car is worth. So at last resort I did what I did. I know it’s not fixing anything just prolonging the inevitable. Of a transmission failure. But from the result so far it’s driving and shifting now the best it has in years . 970 miles post. Atf service it’s adding Lucus.
Rebuilt transmission on a 2013 tahoe; didn't even have it back a full 24hrs. Shifting late, rpms idling high but seem like it don't want to catch speed; Transmission fluid good, torque converter new. Mechanic said Transmission didn't need to be reprogrammed. Can anyone tell me what it could be; also took to the parts store put on machine and it read a code P0741 and C0899-00... can someone help me out with this ik it could be a list of things
Hi my friend a curiosity I have the same gearbox mounted on the opel insignia and it makes me in neutral from 3 to 4 gear, with the diagnosis it gives me error P0741 and P0734 what happened in your opinion?
I'm watching
if only torque pro app showed me those trans values..
what scanner were you using
Hi. How to fix the problem in the video? I have the same problem.
So what was it was it solenoid,valve body or just cleared the code with your computer 🤷🏻♂️
Did you verify solenoid CIRCUIT function? Or did you just disturb the electrical circuit?
The valve in the valve body was bad.
Just saw that in part 2
Thank you!
Very helpful for that model.
I am having this issue on my 2005 gmc envoy 5.3L with the 4l60e trans do do you believe dropping the pan and changing the solenoid or cleaning the old one would fix it. When I hit 40 it just slips
How many miles is on this vehicle?
I have a p0746 pressure solenoid, stuck off. What solenoid would it be?
Great Video and info.. Question should you reset the TAPS Function after replacing all the Shfit Solenoids and Pressure Valve Switch on 08 Silverado? I was getting same code p0741 but now it shifts smooth but didn't reset codes after replacing parts.
You can try. It will not hurt
Sounds good.. Seems truck is shifting smooth at all gears bit was just curious if that reset would hurt anything.. Thanks and keep up the great videos..
I had this code but I was wondering by turning off the code will it come back on so I went for a ride it didn’t come back on the next day I took it for a ride again and see if it comes back on and it didn’t so have to drive it on a highway and do 70 to see but I haven’t try it yet I have a feeling you are right I think it slips but I wait and see hope and pray it doesn’t come back on 🤣🤣🤣🤣🤣
What was the actual repair performed to fix it?
I would have to go through the videos to find out. This is why I have them on youtube for others to do this.
Nothing?
I have the same code 2010 Silverado, so I clean the metal off the tcc valve?
Anyone knows how much fixing a P0471 code would cost on a 2011 Mercedes E350 4Matic sedan ?
Great job
thank you
My truck is doing that rebuilt it 4months ago converter is new
Which TCC solenoid you change the on in the valve body or the one that is wires to the solenoid harness
@@christopherhernandez9115 when taking a guess, you can change both.
@@thisisyourtransmission did you replace valve body or the harness with solenoid?
EXELENTEVIDEO OTRA COSA DONDE ME PUEDO SURTIR LAS REFACCIONES DE UNA CAJA IGUAL
East C-Town!
I just received this code on my 05 Toyota Corolla. How bad is it to drive with the code? It drives completely fine and I plan to fix it soon but it’s my only mean of transportation.
I don't believe this code will make you have an accident, if this is what you want to hear. I guess, drive it until something else goes wrong if you still can move. Normally though, you may see a reduction in fuel mileage.
@@thisisyourtransmission Ok thank you!
I have the same code 01 gmc sierra 4l60E. What happens if I keep driving it slipping for several more months?
Same thing is wrong with mine
I've been driving over a year on a bad 4l60e in a 2011 Colorado. I have no idea what the problem is but last night I changed shift solenoids and tcc solenoid. Didn't make a but of difference.
I have the same scanner but was afraid to start the vehicle with it set up. Is there any way to damage the computer with vehicle running?
Lol. O
Go Browns
I had my transmission rebuild completely and 3 days later I got po 700 and po 0741 any suggestions
In the video, it shows what I am looking for if this code happens. who ever is working on your transmission would have to do the same thing. If not, they will just be guessing.
What city do you live in ?wheres your shop?
Cleveland, Ohio
Do you have any videos on diagnosing torque converter shutter
Shutter no, slipping yes
Is it unusual for the P0741 code to come and go? My car shows no signs of shifting problems or gas mileage issues but I get the check Engine light after about 2 hours of driving. Once on, it stays on until an adequate cool down period occurs, or the next day, then it’s off again?
Normally something is worn when this happens.
Hey man, I had that code pop up on my son's 06 Saab 9-3 2.8t. V6. I removed the valve body and fluid which were terribly dirty. Black fluid. Tested each solenoid, and got the correct 6.5 ohm reading. Cleaned and rebuilt the VB and reinstalled it. I correctly used 12 quarts to flush out old fluid until all fluid was fresh. No more p0741 code, but car still won't drive. Do you think it needs a new torque converter? Thanks
What do you mean the car will not drive? It does not move?
@@thisisyourtransmission It doesn't drive. It will reverse absolutely normal. Neutral seems normal. But when I get it in drive, it takes very high rpm's for the car to barely move a few feet. Occasionally, it will catch at higher revs and take off sluggish. During those times, it will not shift. And once it slows down, its back to not catching.
It has an Aisin TF- 80SC
@@jameswarren4747 take the transmission out and put another one in. Make sure the transmission lines are flushed.
@@jameswarren4747 never replace transmission fluid
thanks
Welcome
My torque converter was physically shaking the car but no codes professionally replaced it now every torque converter code possible replaced all solenoids not fixed until I bought a toyota lol never ever buy American
Lol I have a 2004 honda accord ex v6 and I'm dealing with the p0741 saga.
@@lefty_420 so what happened ? Did you find out what it was ? I'm having the same problem in my 2017 accord v6.
@soulerflare7 I had it looked at and he said my 3rd gear was worn out, basically i need to have my transmission rebuilt.... or replaced. Take it in and have it checked out it's usually free