EZcad Tutorial, Engraving vector on rings, with rotary ring devices. + fiber laser settings

[@k3g1397]

sir , you are the best in teaching , you have solved my 4 years problem , thank you so so much

[@cncpadawan9582]

Where can details be found about using a servo for the rotary? I looked at the blog that was referred to and didn't find anything.

[@rumblemumbles]

how about inside ring engraving?

[@kobylavery4815]

Did you work out the inside of ring ?

[@manimani134]

what is cost of machine of 50w and 100w?

[@evilsoul910]

hi sir i need you help
sir if i engrave a full ring so i can set diameter i can set width also but after marking laser cross the middle point so how i fix this kindly plz tell me how?

[@Spinosaurus44]

I used the same parameters but I keep getting a lot of space between the markings. How can I stop that?

[@maryli9785]

maybe you are on the x axis ?

[@makerspace533]

Your split size is much too large. Change it to 0.5 or smaller.

[@nayf-6338]

الاغاني صوتها اعلى منك