I just got mine in the mail this week... did you notice that Lee doesnt sell or have the Down-stroke Verification Device anymore? and all the current online instructions and videos still have it installed.. i spent 20 minutes looking for it,..i felt like a dumbass... great video! helped me confirm my set up! many thanx!
Your comment is also the reason im looking for info on the newer auto drum. Ive been trying to figure this out for a while now. and vie been reloading for 2 years now.
Great inexpensive measure bought one a couple of years ago and used it on my Redding T7 to reload .223 it never varied more than .2 grains and I never used it for max loads always kept them down by .4 grain. If was reloading anything to max I would hand weigh them wouldn’t trust any measure so for plinking ammo it’s worth the money.
Tell me about your press! You have all of your dies installed in the top so you don't have to replace each die for each operation(resizing,expanding, bullet seating etc.) Do you have to swivel each die inline with the die piston ? How does that work?
It’s a Lee 9mm loadmaster. Setup the dies and put brass in the brass feeder. Place bullet on charge case, pull the handle and repeat. Awesome press. 🤘😎🤘
E un figata e precisa
I just got mine in the mail this week... did you notice that Lee doesnt sell or have the Down-stroke Verification Device anymore? and all the current online instructions and videos still have it installed.. i spent 20 minutes looking for it,..i felt like a dumbass... great video! helped me confirm my set up! many thanx!
Your comment is also the reason im looking for info on the newer auto drum. Ive been trying to figure this out for a while now. and vie been reloading for 2 years now.
Great inexpensive measure bought one a couple of years ago and used it on my Redding T7 to reload .223 it never varied more than .2 grains and I never used it for max loads always kept them down by .4 grain. If was reloading anything to max I would hand weigh them wouldn’t trust any measure so for plinking ammo it’s worth the money.
Do you perform belling during powder charging
Yes just enough to get the bullet to sit flat and not shaving the bullet.
everything seems to be ok on mine, but the drops are very inconsistent like 2.90 to 3.2 ... 0.3 grains !!
Tell me about your press! You have all of your dies installed in the top so you don't have to replace each die for each operation(resizing,expanding, bullet seating etc.) Do you have to swivel each die inline with the die piston ? How does that work?
It’s a Lee 9mm loadmaster. Setup the dies and put brass in the brass feeder. Place bullet on charge case, pull the handle and repeat. Awesome press. 🤘😎🤘
Hey someone. I bought one of these and it doesn't pour when I pull the press. Am I doing something stupid or wrong?
Try to rotate the adjustment key of the drum
Check to see if you are using small case or large case set up
Small case for my 9mm