Solidworks CFD Tutorial | Free Surface | Transient Explorer | Which Bottle will fill first and when

Free Surface | Transient Flow Analysis | Transient Explorer
Which Bottle will Fill First?? Checking using Solidworks CFD.
1. Embossing Non Linear 2D Simulation Study in Solidworks | Nonlinear Stress Analysis in Solidworks
• Embossing Non Linear 2...
2. Bending Nonlinear 2D Stress Analysis in Solidworks | Bending by V-die and Wiping die
• Bending Nonlinear 2D S...
3. Analysing Impact of Adding Ribs in design of a Plastic Sitting Stool | Static Simulation solidworks
• Solidworks Static Simu...
4. Simply Supported Beam Simulation Study in Solidworks For Shear Force and Bending Moment Diagram
• Solidworks tutorial: S...
5. Cantilever Beam SFD (Shear Force diagram) and BMD (Bending Moment Diagram) in solidworks
• Cantilever Beam SFD (S...
6. Ducted Fan designing and CFD in solidworks (tutorial)
/ @solidworksfunpraveens...
7. Airplane wing CFD in Solidworks with various angle of attack (for calculations of lift)
/ @solidworksfunpraveens...
8. 2 Blade, 3 Blade and 4 Blade Propeller CFD in Solidworks (tutorial)
• Solidworks CFD tutoria...
9. Contra Rotary Propeller CFD in Solidworks (for Thrust calculation)
• Solidworks CFD tutoria...
10. Venturimeter CFD in solidworks
/ @solidworksfunpraveens...
11. Solidworks Plastics Simulation of a Plastic Desk Pen Holder
• Solidworks Plastics Si...

[@diegoss3563]

Excelente tutorial, me sirvió mucho, gracias!!

[@SolidworksFunPraveenSingh]

thanks!!

[@ConveyorMan]

Thanks.

[@29Gleisson]

very nice tutorial! Thank you

[@SolidworksFunPraveenSingh]

thanks.

[@AminRahimi-1]

Hi Praveen how are you?
It was really good.
I use this but I faced this error:
((
Solidworks_CFD_Tutorial_Free_Surface_Transient_Explorer_NV5Tnz2BL4Q
))
whats the problem?
I googled it and double check my model too and I have your version of solidworks, too.
??

[@danielwieczorek7820]

Hello that's a nice tutorial. What if all the lids were closed? How can I simulate moving the water around a closed system?

[@SolidworksFunPraveenSingh]

Thanks. Even if all the lids are closed then also You will have to provide inlet from somewhere inside the closed volume instead of the lid's surface.

[@danielwieczorek7820]

@@SolidworksFunPraveenSingh Thank you for answer. If the top tank is full of liquid, how can I simulate the liquid flowing to the others in a closed loop?

[@SolidworksFunPraveenSingh]

Here is a Tutorial:
ruclips.net/video/p7jtf0xHYN4/видео.html
Hope this may help!

[@rahulsanjhira2595]

Hi In my flow simulation wizard option there is no free surface option available. I am using SW2017

[@SolidworksFunPraveenSingh]

Free surface was introduced in SW 2018

[@rahulsanjhira2595]

So how to solve this problem in 2017 version

[@SolidworksFunPraveenSingh]

try using time dependent CFD or transient flow analysis.