This tool should only clutch slip in the clockwise direction, how do you remove a screw CCW if it slips. Can you have lock this tool for full torque in counter clockwise direction??
I didn’t understand, how choices a correct value?for example if i want 20 LB I should turn it to the number 2 point? What is meant those number 0.9 0.8 ... ?
Cool guys let me clear the readings from 1 to 6 Nm are main values and the readings are from 0.1 to 0.9 are secondary scale let's say if you want to sett for 4.5Nm. first you need to turn to it number 4 and to get 0.5Nm again you need turn 0.5Nm on secondary scale to horizontal line on main scale. Hope I have answered for doubts if you want any doubts regarding torque instruments please contact me I will help
I bought this. Very disappointed, it does not click when torque value is reached, instead, a clutch slips which suggests to me possible over tightening. Also driver is not magnetic so it will not hold short bits.
This tool should only clutch slip in the clockwise direction, how do you remove a screw CCW if it slips. Can you have lock this tool for full torque in counter clockwise direction??
I didn’t understand, how choices a correct value?for example if i want 20 LB I should turn it to the number 2 point? What is meant those number 0.9 0.8 ... ?
@Carl Jito 🤦🏻♂️
Don’t feel bad, I wondered the same
Cool guys let me clear the readings from 1 to 6 Nm are main values and the readings are from 0.1 to 0.9 are secondary scale
let's say if you want to sett for 4.5Nm. first you need to turn to it number 4 and to get 0.5Nm again you need turn 0.5Nm on secondary scale to horizontal line on main scale. Hope I have answered for doubts if you want any doubts regarding torque instruments please contact me I will help
Where can I buy one of these in the uk please? Many thanks👍🏼😁
How many nm do you need for building pc? Please help
:-) if the screw breaks, then it's too much ..
@@michalniznik4881 Tighten up until it strips and then back it off a quarter turn
how i can get the catalog for this
Ezoo Ahmed we accept bulk order
i still dont know how to use it. lol
Please connect me i will explain madam I have good experience
I bought this. Very disappointed, it does not click when torque value is reached, instead, a clutch slips which suggests to me possible over tightening. Also driver is not magnetic so it will not hold short bits.
Which make sir?
torque screwdriver lore
מדהים
How do you remove the bits?
How do you make them stay in?
@@williamstorms3262 you have to push them in with force until they click. And they pull out hard the first few times you use it as well
I cannot fit and tight the bit
just a load of crap music i was pissed off so switched off
Worthless! This didn't explain how to set given values, such as 18 in/lbs or 45 in/lbs.
You need to convert to Newton-Metres (Nm)
1 Nm = 8.85 in-lbs so....
18 in/lbs = 2.0 Nm
45 in/lbs = 5.1 Nm