I have a 2020 Nissan Altima and you don't have to removed all that uncessary plastic on top of the bumper cover or removed the front bumper cover like A-1 shows here. You can jack up the car, turns the wheel to the left and/or take off the wheel then unclip few push rod clips, from under the wheel well and under the car then pull the plastic away to access the windshield washer tank then change your sensor without removing all these uncessary panel, plactic covers, and front bumper cover. Also, to make it easier in pulling he sensor out, use a heat gun and slightly heat up the bottom of the washer tank where the sensor sit and that will soften plastic and allow you to remove the sensor easily.
thank you! I have a question. Low washer fluid warning light keeps coming on after changing the front bumper of my infiniti m37. Never been before. The cut of electrical wire of washer fluid sensor may cause the low washer fluid signal ? I wonder the cut of the electrical wire cause low signal , or no signal despite of empty washer fluid.
Hello, thanks for the video. I repaired my washer pump on my Nissan primera p11. Is the sensor inside the washer pump on this model? Because when i inserted it again my washer light de don't work at all.
If you've never worked on a car, don't even attempt this. And yes the dealer cost for such a replacement is rather expensive for what's described here as a "simple job".
Can A Mechanic Cut A Wire Easy To The Windshield Wiper Indicator Sensor? When The Car Is Up In The Air At Car Shop? Went In...For An Alignment And Tire Rotation. Service Performed...But, Notice That Windshield Fluid Indicator Light Was On. Mechanic LIED About Rotating My Tires...Guess, He Was Too Busy Messing Up My Car To Generate More Money For The Shop. 😡
√ *Watch the Video*
√ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto
√ *Do it Yourself*
√ *Save Money*
I have a 2020 Nissan Altima and you don't have to removed all that uncessary plastic on top of the bumper cover or removed the front bumper cover like A-1 shows here. You can jack up the car, turns the wheel to the left and/or take off the wheel then unclip few push rod clips, from under the wheel well and under the car then pull the plastic away to access the windshield washer tank then change your sensor without removing all these uncessary panel, plactic covers, and front bumper cover. Also, to make it easier in pulling he sensor out, use a heat gun and slightly heat up the bottom of the washer tank where the sensor sit and that will soften plastic and allow you to remove the sensor easily.
thank you! I have a question. Low washer fluid warning light keeps coming on after changing the front bumper of my infiniti m37. Never been before. The cut of electrical wire of washer fluid sensor may cause the low washer fluid signal ? I wonder the cut of the electrical wire cause low signal , or no signal despite of empty washer fluid.
Hello, thanks for the video. I repaired my washer pump on my Nissan primera p11. Is the sensor inside the washer pump on this model? Because when i inserted it again my washer light de don't work at all.
Working principles for level sensor
If you've never worked on a car, don't even attempt this. And yes the dealer cost for such a replacement is rather expensive for what's described here as a "simple job".
Can A Mechanic Cut A Wire Easy To The Windshield Wiper Indicator Sensor? When The Car Is Up In The Air At Car Shop? Went In...For An Alignment And Tire Rotation. Service Performed...But, Notice That Windshield Fluid Indicator Light Was On. Mechanic LIED About Rotating My Tires...Guess, He Was Too Busy Messing Up My Car To Generate More Money For The Shop.
😡