MGB, MG B, 1963: CLUTCH AND BRAKE MASTER CYLINDER FIX PART 2

Поделиться
HTML-код
  • Опубликовано: 18 окт 2024

Комментарии • 7

  • @bshnabel
    @bshnabel 2 месяца назад

    Nice car & video, thanks

  • @thierry4257
    @thierry4257 2 месяца назад

    super video, tres détaillée. Merci beaucoup.

  • @Nickcirrus
    @Nickcirrus 11 месяцев назад

    Great video

  • @MGB-learning
    @MGB-learning Год назад +1

    Great video!

    • @mgbsandotherstuff2982
      @mgbsandotherstuff2982  Год назад +1

      Thanks for the comment. I just started using a new video editor and have to work on the audio bits.

  • @johnvalentine4909
    @johnvalentine4909 Год назад

    Hello again. Good repair video. One thing I have found to be useful when reinstalling the clutch/brake unit is to remove the large rubber plug that goes through the firewall directly behind the assembly. The first bolts you should install (finger tight) are the ones holding the assembly to the firewall. Then, with the Rubber Plug out, you can easily install the 2 Banjo Bolts on the back of each master cylinder. Follow with the rest of the hold down screws. Check that all are tight, install the pedals as you did and you're done.
    I must say that your videos are very well done and are always a joy to watch. I even find myself saying " OK, next we should be putting the ---- together" and that's exactly what you do! Its almost like you can hear me! Looking forward to the next one.
    At present, in my garage, I'm finishing a '67 MGB-GT Special. Installing the Dash and wiring it up. Next will be installing the Headliner which is a job I will need some help with. Good luck!
    John

    • @mgbsandotherstuff2982
      @mgbsandotherstuff2982  Год назад +1

      Thanks John, that is very kind of you. I certainly am learning as I go and building an inventory of tools and knowledge. Especially from the comments I get. I will say though that I sometimes have overdub a lot of audio until I eventually figure something out.