Going to be doing this job next weekend weather permitting so great video, will help a lot. My front left is sticking due to rust by the looks, not enough use with brake pads low so after changing the pad the bit that was protruding with worse pad (piston wall) is corroded like yours but worse :)
At six minutes the stuff on the bleed nipple is probably Plumbing tape. I recently bleed an NC1. Both rear calipers were sucking air as they were being bleed. The nipples 5:58 needed to be removed, given 3/4 turns of the tape to allow a proper bleed. Oddly the front nipples were fine. You vids don’t get the exposure they deserve.
Need to do exactly this to mine, as always super helpful vid and I've ordered the parts you linked to, muchos gracias!
Just replaced my pistons and this video is the only reason I believed I could do it. Thank you very much you awesome human.
Great video, wish i saw this a week ago when i swapped my piston. I'll get the sliding pins done too now with some tips you shared thank you again.
Glad I could help. Go like that video🙂
Going to be doing this job next weekend weather permitting so great video, will help a lot. My front left is sticking due to rust by the looks, not enough use with brake pads low so after changing the pad the bit that was protruding with worse pad (piston wall) is corroded like yours but worse :)
6/2023 greetings from germany ....
Hi, It looks like you did a nice job , but you shouldn’t clamp off the brake hose because I think you can damage the inside of it.
Hi can I take the calliper off without getting the piston out first?
Yes
At six minutes the stuff on the bleed nipple is probably Plumbing tape. I recently bleed an NC1. Both rear calipers were sucking air as they were being bleed. The nipples 5:58 needed to be removed, given 3/4 turns of the tape to allow a proper bleed. Oddly the front nipples were fine. You vids don’t get the exposure they deserve.
you deleted the other video so i cant see all the comment reply, do you mind telling how much it roughly cost :)
The turbo costs are on a spreadsheet with link on turbo videos. If I have missed on some turbo videos, it is def under intro video.