Engine Measuring Camshaft Lobe Lift
HTML-код
- Опубликовано: 8 сен 2024
- This video is part of a basic engines course that is taught at Weber State University. The video describes the procedure for measuring the camshaft lobe lift. Cylinder Head Videos
- Replace a Valve Stem Seal: • Replace Valve Stem Seal
- Valve Spring Inspection: • Valve Spring Inspection
- Cylinder Head Valve Stem To Guide Clearance: • Cylinder Head Valve St...
- Check an Engine Cylinder Head and Block for Warpage • Check an Engine Cylind...
- Measuring the Camshaft Bore: • Measuring the Camshaft...
- Measuring the Clearance of Camshaft Bearings: • Measuring the Clearanc...
- Engine Measuring Camshaft Lobe Lift: • Engine Measuring Camsh...
- Adjusting Valve Lash on Cummins 5.8l Engine: • Adjusting Valve Lash ...
Engine Block Videos:
- Main Bearing Bore Check: • Main Bearing Bore Check
- How to measure the crankshaft run-out: • How to measure cranksh...
- Crankshaft Main Bearing Journal Measurements: • Crankshaft Main Bearin...
- Evaluating Piston Rings: • Evaluating Piston Rings
- Explanation of the Connecting Rod Side Clearance Measurement: • Explanation of the Con...
- Measuring Cylinder Bore Out Of Round And Taper with a Dial Bore Gauge: • Measuring Cylinder Bor...
Thanks for explaining how to use the micrometer
Good 👍👍👍👍
thanks
hi im new 2 this but i think my new cam is ground wrong. i measured the lobe suptracted the minor fm the major diameters . i got 8.5mm intake & exh 9.0mm. now the cam card says .564 valve lift intake . & 534 exh
i multiplied it by my rocker ratio 1.6 =9.0 mm intake did the same 4 the exh = 8.5mm. the exact oppisite.
is it a coinsidance or hav i done something wrong. p.s.9.0mm convted to inches is 354" & 8.5mm is 334" .
Tx
Very nice video, liked and saved but can you use the first method to deternine the lift from an asymmetrical camshaft?
As long as you can read the position with the valves fully closed and then fully open you should be able to determine lift.
@@ScottHadzik thanks Scott!
Students of Mr.ET,
Refer this video