Installing Quantum Fuel Systems fuel pump on Husaberg FE350

Поделиться
HTML-код
  • Опубликовано: 11 сен 2024
  • I replaced the OEM fuel injector pump system on my Husaberg FE350 with replacement from Quantum Fuel Systems. It fits spot on and is very easy to install.

Комментарии • 5

  • @leu002
    @leu002 7 месяцев назад

    Hello! Please help! My 2011 berg fe450 won’t start. I washed it and blow the water with compressed air. after I started it for 10 min and drive 2 km. Then I turned off. All good. After one week bike won’t start. Dash dead. FI no light. No blown fuses. I replaced dash battery. Engine is turning but won’t start. I put contact spray in all joint. Nothing. When I made a bridge from + to fuse 1, gas pump started and FI on but I don’t hit start afraid not to burn smtg. I don’t find power relay to test it!

    • @One-Wheel-Drive
      @One-Wheel-Drive  7 месяцев назад

      Check the fuel pump relay. There should be two identical relays somewhere, one of them is for the headlight, the other is for the fuel pump. On FE350 they are on the right side of the subframe. Both are identical, so you can switch them and try.

    • @leu002
      @leu002 7 месяцев назад

      @@One-Wheel-Drive can u show me a photo of them? Thanx

    • @One-Wheel-Drive
      @One-Wheel-Drive  7 месяцев назад

      Unfortunately I don't have that bike anymore. Sold it last September. The relays on 2013 FE are a bit hard to find as they are kind of tucked "inside" of the subframe. I remember it took me a while to locate them. Not sure if they are at the same location on your 2011 FE450 but I would assume they are. @@leu002

    • @leu002
      @leu002 7 месяцев назад

      @@One-Wheel-Drive hi! I give power from + to fuse no 1 and I push start. After The bike started I give up at bypass and the bike runs well but I don’t have electricity to dash and FI. After I shut off doesn’t start until I Gică again power from +. Can u send some ideas?