【#02】MP4/5B ノーズコーンをリアルに加工！【1/20 TAMIYA】Really process the nose cone!

[@danmurphy5889]

Wow such a massive improvement over the original kit

[@Car_model_channel]

Thank you!

[@damianjwb79]

Your a master at this craft! Very talented

[@Car_model_channel]

thank you！ I’m very happy.😃

[@tommywevape7212]

You are such a prototyper！

[@Car_model_channel]

Thanks !

[@EVOSparksDieCast]

Nice😊! Keep it up!

[@Car_model_channel]

thank you！I will do my best!

[@jonnyspa27]

Thank you for sharing this technique! I'm wanting to do a similar process for a few F1 & Indycar builds with the suspension.
How do you know if the pin location is correct so the car sits squarely to the ground? Do you simply place the pin hole in the middle of the suspension arm gap? I hope this makes sense as I'm wanting to learn. Thanks again!

[@Car_model_channel]

Thank you for your comment! It's difficult to explain in detail, but I think if you work carefully one by one, you can create something good. I hope the video is helpful.

[@jonnyspa27]

@@Car_model_channel Thanks for that. I wasn't even sure if I was stating the process correctly. I suppose it's all trial & error. I will always be learning here! :D

[@7mt.218]

こんにちは！ノーズカットも凄いけど、ノーズの反りの修正参考になります😵

[@Car_model_channel]

こんにちは^_^
ノーズコーンのカットは初めてなのですが、反りがけっこう大きかったので修正してみました。
独自のやり方を試行錯誤しながら進めてますので、もっと違う方法があるかもしれません💦

[@thiagobartolo]

I didn’t understand why it needed an angle adjustment. Was the length of the chassis shortened after the alterations?

[@Car_model_channel]

When I cut the nose, the angle changed due to the plastic material. I added a plastic plate to adjust the length.
Thank you!

[@doguhan36]

What kind of plastic did u use?

[@Car_model_channel]

I used an ordinary plastic plate. The thickness is 1.0mm and 1.5mm.