Hello, thanks for a great guide. is it possible to make R14 primary and REX7 Assist as secondary (to try assist in a jet, which runs off an R14). I have seti it all up, both work via PPM, all ok if primary gets disabled, but no assist function on R14, seems PPM only sends TX data, no EX bus option on that R14, please help if it is possible somehow :)
No. The Assist can only stabilise the servo sockets or Exbus output. It cannot stabilise Sbus, PPM etc. Also, even if you could use Exbus to the R14 you would not get stabilisation unless the primary 14 lost radio contact and switched to using the secondary Assist rx data.
@@cotswoldpilot thanks for insane fast reply. What do you suggest then to try assist on a 14ch plane? Instead R14, to buy Control box with exbus input, and use ex7assist + rsat2?
Hi Mr Curzon, i have that configuration, but with an rex9 and r3; both receivers are seen as TXP and TXS, but when i disable one of the transmisions, i loose the control of the servos, i do have dual path, and see both siganls comming from the tx and arriving into the rx independtly, any idea? Best regards, and thanks for your channel
I made it work, with the r9 and r3, the r9 with serial link on jetibox and servo, cable pluged both receivers into the chanel sat on the r9 and channel 3 on the r3 rx, and the r3 ppm positive
Thanks Harry! Should i disable the fail safe on the secondary receiver?
Thank you very much for this
Hello, thanks for a great guide.
is it possible to make R14 primary and REX7 Assist as secondary (to try assist in a jet, which runs off an R14). I have seti it all up, both work via PPM, all ok if primary gets disabled, but no assist function on R14, seems PPM only sends TX data, no EX bus option on that R14, please help if it is possible somehow :)
No. The Assist can only stabilise the servo sockets or Exbus output. It cannot stabilise Sbus, PPM etc. Also, even if you could use Exbus to the R14 you would not get stabilisation unless the primary 14 lost radio contact and switched to using the secondary Assist rx data.
@@cotswoldpilot thanks for insane fast reply.
What do you suggest then to try assist on a 14ch plane? Instead R14, to buy Control box with exbus input, and use ex7assist + rsat2?
CB200/210/220, Assist, rsat2
@@cotswoldpilot Thanks a lot Harry 👍
Hi Mr Curzon, i have that configuration, but with an rex9 and r3; both receivers are seen as TXP and TXS, but when i disable one of the transmisions, i loose the control of the servos, i do have dual path, and see both siganls comming from the tx and arriving into the rx independtly, any idea? Best regards, and thanks for your channel
You are using the wrong system, see this video
ruclips.net/video/-_A318nj8cw/видео.html
Harry Curzon sorry i am using an R9 and r3rsw, that rxs wont work?
I made it work, with the r9 and r3, the r9 with serial link on jetibox and servo, cable pluged both receivers into the chanel sat on the r9 and channel 3 on the r3 rx, and the r3 ppm positive