Ep. 8 Shop Car Tube Front Fabrication!
HTML-код
- Опубликовано: 7 сен 2024
- Weekly shop walk around and then Matt and Mark go into detail on fitting the tube front on the shop car. Plus a shop dog appearance!
Hoping to get the motor and transmission mounted in the next video. New parts are arriving daily!
www.Mooreracechassis.com
moore_race_chassis
/ mooreracechassis
I loved seeing your pets, they are pure and true friends. Congratulations I have learned a lot with your tips. Thank you.
You guys do very nice work!! Love to see quality
It’s awesome that you guys keep your shop clean so that the dogs can come out and play, metal slivers in paws would be bad
Nice shop and nice work!! First video I watched of yours. I know all about the hours that the little this add up to. I have 2400hrs in my car. But as you know if you just keep picking on them they will eventually be done and then it's all worth it. Gonna keep watching the progress on these cars.
Thank you!!!!
Just came over from john doc. I enjoy the fabrication side as much as racing. Im subd up💪
Thanks dude! We appreciate it!!!
Mikes car is going to awesome!
Yes it will!!!!!
The bar at 20:44 , Have you thought about hammer and dolling. The metal to straighten it with the tubing?
It wont stretch that far. Its possible if it was longer.
Do you guys have a tube front end kit that you can buy to go with your 25.3/2 chassis
Unfortunately we do not....
@@mooreracechassis where did you run the two center chassis bars behind the k member?
The two frame rails when you're building a double frame rail car or single frame rail do you run 1 inch and 5/8 from cab to end of motor compartment
Yes. usually terminate them by the mid plate and connect them back to the kmember.
What size bars do you guys run up the strut tower
Are those strut bars inch and a half
Yes they are.
Which k-member is in the shop car?
Racecraft ultra swap.