Hey man, thanks for the video. I don’t own a torque wrench (iv seen your other reply) but I’d rather it was correctly installed. Is that 3/8 torque wrench u used? Im going to order one. Thanks
@@TheBTRGaragethanks man. Iv watched several videos on the Cusco instal and yours was by far the most detailed and best camera angles especially on the master cylinder part. I’ll get one ordered today as i know I’ll need it going forward. Cheers from Ireland
I bet that looks great! Iv just ordered the t wrench so in a few days I’ll be able to install. I’ll check out some of your other vids tonight dude! Keep it between the hedges, talk again. 😊
Very slightly improved brake pedal feel, it's not very noticeable. The master cylinder flex gets worse over time (without the brace), I've seen some gen1's that have a visible ~1/2" of flex.
*I'm thinking about getting the Cusco bar anodized to match my Trueno Blue car. What do you think?!*
Yes
will look great!!!!!
Thank you!
Nice 👌🏼 one well done 👍🏼 good demo and info thanks, from England 🏴
Thanks 👍
@@TheBTRGarage You’re welcome 🏴
Did you notice a difference with the MBC on autocross/track? I’ve been eyeing this same setup
Very minor improvement to brake feel, nothing crazy though.
Quality videos. Thanks!
Glad you like them!
will you need an alignment again after this?
@@NJ_Galactic Nope.
@TheBTRGarage thanks man, I installed one on my old Z and took it to the alignment shop like an idiot because I was worried about tire wear
what if i dont have a torque wrench to measure the lbs-ft of torque on each nut?
The top shock nuts are very low torque, so just hand snug is fine. No need to crank them down.
Bought a carbon fiber one
Hey man, thanks for the video. I don’t own a torque wrench (iv seen your other reply) but I’d rather it was correctly installed. Is that 3/8 torque wrench u used? Im going to order one. Thanks
Yep! 3/8" drive torque wrench.
@@TheBTRGaragethanks man. Iv watched several videos on the Cusco instal and yours was by far the most detailed and best camera angles especially on the master cylinder part.
I’ll get one ordered today as i know I’ll need it going forward. Cheers from Ireland
Awesome, glad the video is helpful. I just got my Cusco bar custom powder coated smoke/black and it looks great now!
I bet that looks great! Iv just ordered the t wrench so in a few days I’ll be able to install. I’ll check out some of your other vids tonight dude! Keep it between the hedges, talk again. 😊
awesome video!!!
Thank you!
How does it feel compared to stock?
Very slightly improved brake pedal feel, it's not very noticeable. The master cylinder flex gets worse over time (without the brace), I've seen some gen1's that have a visible ~1/2" of flex.