Chevrolet S10 1995 4.3 Fuel pressure regulator Replaced

Поделиться
HTML-код
  • Опубликовано: 5 окт 2024

Комментарии • 37

  • @uniteentierly2773
    @uniteentierly2773 Год назад +3

    Man, that's some good camera footage. Thanks Sir.

    • @acord1578
      @acord1578  Год назад

      Your welcome boss👍🏻👍🏻

  • @cuddeh808
    @cuddeh808 5 месяцев назад +1

    super helpful and right to the point. thank you sir

  • @kandi7188
    @kandi7188 4 года назад +4

    Thanks for making this. It helped me fix my truck. God Bless you man.

    • @acord1578
      @acord1578  4 года назад +1

      Kandi Cane thank you for your comment and god Bless you to🙏👍

    • @eloneverett4318
      @eloneverett4318 3 года назад

      @Nico Tristan yup, been watching on flixzone} for since december myself =)

    • @miloroyce2797
      @miloroyce2797 3 года назад

      @Nico Tristan definitely, I have been using Flixzone} for since december myself =)

  • @williamarchie
    @williamarchie 3 года назад +2

    All I can say is I better put some antiseize or pipe joint compound on those screws cause they will leak tighten the middle two first then the back after u tghten the others snug the middle and back again good luck

  • @renzo4296
    @renzo4296 3 года назад +1

    Thank you very much, I have the same motor and have to do this also. Thank you.

    • @acord1578
      @acord1578  3 года назад

      Your welcome 👍👍

  • @catfish4721
    @catfish4721 4 месяца назад +1

    I’m not getting any fuel to my injectors when cranking checked fuel pump pressure is good and checked my fuses look good and fuel pump relay is good

    • @acord1578
      @acord1578  4 месяца назад

      check! Fuel Filter.

  • @xxsilverxxfox5153
    @xxsilverxxfox5153 2 года назад

    Terrific video thank you

    • @acord1578
      @acord1578  2 года назад

      Thank you very much God bless you 🙏

  • @lloydpullen744
    @lloydpullen744 3 года назад +1

    Great self help video

  • @markobrien4103
    @markobrien4103 3 года назад

    How did you know that the Fuel Pressure Regulator needed replacing? I am chasing an issue and I think this might be it. The truck runs rough at idle.. I thought it was spark, so I replaced the plugs/wires/distributer cap/rotor. Still rough, so I did the EGR valve/Map sensor/ IACV.. still rough so I did the fuel filter/air filter/ both injectors.. still rough

    • @acord1578
      @acord1578  3 года назад +1

      check your fuel filter!!!

    • @domaniclarsen3891
      @domaniclarsen3891 3 года назад +2

      Gotta test your fuel pressure. Get a fuel pressure testers and attach it to your inline filter. You’ll need a tbi adapter to do this. There’s a couple videos of it. If your fuel pressure is low it’s your fuel pump, in-line filter or pressure regulator. Also check your spark plugs. If they’re black and it’s blowing black smoke/backfiring then it’s probably your pressure regulator. If the fuel pressure is fine and your spark is fine it could be your timing. If your timing is fine then you’ll have to do a compression test.

  • @c956rubber
    @c956rubber 2 года назад +1

    Is there a reason for the black o-ring that you didn't use?

    • @acord1578
      @acord1578  2 года назад +1

      That o-ring was for another car i wasn't fixing that day at same time!!

    • @c956rubber
      @c956rubber 2 года назад

      @@acord1578 thanks for your quick response, great vid by the way.

    • @acord1578
      @acord1578  2 года назад +1

      @@c956rubber your Welcome!!! brother,

  • @Shomeboi79
    @Shomeboi79 Год назад

    How did you know it was bad? What symptoms did the truck have?

    • @acord1578
      @acord1578  Год назад

      The engine is shaking a lot!!!

  • @blacktopknowledge
    @blacktopknowledge Год назад

    Yo what are the clips with gaskets call I need to replace those too

    • @acord1578
      @acord1578  Год назад

      came new when you buy the Fuel pressure Regulattor

  • @19malaquias
    @19malaquias 3 года назад

    Could i be miss firing because of this ?

    • @domaniclarsen3891
      @domaniclarsen3891 3 года назад

      No miss firing will be due to spark plugs wires ignition module distributor cap rotor or timing.

  • @Livemusic1800
    @Livemusic1800 3 года назад

    Help!!! My chevy 1990 turns on fine. However when i accelerate it stalls like no gas goes thru. Help !!!!

    • @acord1578
      @acord1578  3 года назад

      Check your gas pressure and gas filter

  • @bjdees9202
    @bjdees9202 3 года назад

    My 1982 gmc s15 4.3 tbi engine fuel not working

    • @bjdees9202
      @bjdees9202 3 года назад

      Ut spark plug fires but will not get spray to injector even when fuel working on bypass procedure anyone got a asnwer

    • @acord1578
      @acord1578  3 года назад

      @@bjdees9202 check!! fuel presure!

  • @melvinsabillon123
    @melvinsabillon123 Год назад

    Que Asia su carro

    • @acord1578
      @acord1578  Год назад

      temblama mucho!! i con este canbio se compuso