Just did one. Eeprom read, start key and writing was "successful" when i get back to car silent alarm still flashing blinkers and red light on cluster still blinks. No crank still. Any ideas?
Havent been back to vehicle to finish yet. A couple JLR techs have told me you must purchase a new CEM if car was locked when keys were lost. Which i dont believe, but not any success videos that ive actually found yet. I imagine one might need JLR SDD software in order to control the ignition and active alarm status. Also, removing all fault codes is an issue when AKL.
Every shows the soldering and key program "success" but ive yet to see full video of programming AND going back to vehicle and using the working key. Lol
..What is "the second phase of the whole operation"? I figured that you had a part two video, but no. Did you have to do anything special after the "make start key" function and writing the .BIN file back to the module? I went and read the keys and they now match the key ID's for the missing keys, but the vehicle still will not start. Is there a synchronization step that i am missing?
Which type of Range Rover is this and year please I would like your response for me to learn I like to watch your videos
Did anyone find the solution to the vehicle not starting?
Does it matter how many what’s the 10k resistor is?
How find right key frequency?
Did you removed costing before soldering?
Just did one. Eeprom read, start key and writing was "successful" when i get back to car silent alarm still flashing blinkers and red light on cluster still blinks. No crank still. Any ideas?
I have the same problem, how did you do it?
Havent been back to vehicle to finish yet. A couple JLR techs have told me you must purchase a new CEM if car was locked when keys were lost. Which i dont believe, but not any success videos that ive actually found yet. I imagine one might need JLR SDD software in order to control the ignition and active alarm status. Also, removing all fault codes is an issue when AKL.
Every shows the soldering and key program "success" but ive yet to see full video of programming AND going back to vehicle and using the working key. Lol
Why do you put the resistor between the wires?
Привет, подскажи пожалуйста как решали вопрос?@@Eurosmithpro
Where are you located?? I need this done.
Nigeria. Umuahia Abia state
Can you locate the T1 resistor
I wish I had one at hand
..What is "the second phase of the whole operation"?
I figured that you had a part two video, but no.
Did you have to do anything special after the "make start key" function and writing the .BIN file back to the module?
I went and read the keys and they now match the key ID's for the missing keys, but the vehicle still will not start. Is there a synchronization step that i am missing?
I have the same problem, how did you do it?
😮Привет, помогите пожалуйста, как решили вопрос?
Did you removed the t1 chip?
Yes