I cut grass for a living. Had to replace throttle cable before it broke. Working on small equipment is a must to save repair money. Videos like this are essential to me. Thanks.
Thanks for really detailed video . Everybody dreads springwork that go pop and then you have to figure it out . I will have laptop beside me when doing this repair . Just excellent content .
Just realized that I used this video one year ago to replace cable on my Kombi KM85R machine . The clear nylon inner sheath must have frayed and disappeared causing actual metal cable to fray . Thanks again .
Good video. I used it to help replace the bare throttle cable on an HT-101 Stihl power pruner. A lot more involved as you had to loosen the carb to replace the old plastic cable transition guide on top with a new and improved one which allows for the protective cable sheath to run nearly the full length of the cable to the carb. Much better installation now.
What a great video. Thank you for taking your time to explain this. Very well done. I wasn’t looking forward to doing this job, you definitely made it a lot easier.
Your video saved my day as I had replaced the ignition coil on the FS90 and to get to the bottom screw on the ignition coil , I had to remove the white housing where the shaft connects and later I noticed that the throttle cable was just hanging lose. So I took all the stuff off to get to the carb throttle lever and did not matter how I attached the cable ist always fell out and the reason is I was routing it the wrong way as I did not remove it ,l so did not see how it was attached. So after over an hour I checked RUclips and seen your amazing video and that saved me. Thanks for posting it.
Thanks, well done, and doing it myself saves me a shop fee of $108/hour (can you believe the greed!). I took it apart, but wasn't sure of the spring placements. The throttle cable had worn almost through.
My fs120 is stretched under the handle and was hoping I could just adjust or tighten it up some but not sure how yet. Probably should just replace it anyway. Thanks for the upload 👍🏼👍🏼
Thanks, especally for showing us how to put the springs back on... they had popped out when I took it apart and I was stumped about which spring went where.
appreciate the vid ! im converting a fs 250 brush cutter from bicycle handles to a pistol grip handle and couldnt figure out how the cable & wires hooked up in the handle
Hi Mike,,,,,Do that go for a stihl 100rx trimmer also.,,,My cable is little short,,,,,i torqx screw on top of carburetor going to cable,,,,,,but online i read,,,, it a slide next to your handle that u slide on your handle,,,,and slide the clip forward,,,,,,Thanks
No sound starting at 2:39 continuing with no sound until 3:11. Though something was wrong with the devices I’m watching this on. Nope. For some reason the maker of the video cut the sound off. Why? Opened and closed the RUclips app on my iPad, still no sound. Turn my iPad off and back on, still no sound. Finally fast forward and there is sound. Why you would cut the sound off like that is beyond me kind of annoying as I thought there was a problem on my end.
I cut grass for a living. Had to replace throttle cable before it broke. Working on small equipment is a must to save repair money. Videos like this are essential to me. Thanks.
You are a life saver. I could not figure out that tiny spring that holds the trigger lock out. I was about to meltdown. Thank you man
Thanks for really detailed video . Everybody dreads springwork that go pop and then you have to figure it out . I will have laptop beside me when doing this repair . Just excellent content .
Just realized that I used this video one year ago to replace cable on my Kombi KM85R machine . The clear nylon inner sheath must have frayed and disappeared causing actual metal cable to fray . Thanks again .
Excellent video; so well done!! Just what I needed to replace a frayed cable on my FS90R.
Great drop so helpful to avoid costly workshop repairs. I need to do my FS90R soon notice the cable was fraying when fitting a new carb.
Good video. I used it to help replace the bare throttle cable on an HT-101 Stihl power pruner. A lot more involved as you had to loosen the carb to replace the old plastic cable transition guide on top with a new and improved one which allows for the protective cable sheath to run nearly the full length of the cable to the carb. Much better installation now.
Maverick Trader Super video!!
Thank you so much without this video i couldn't done it. Excellent!!!
What a great video. Thank you for taking your time to explain this. Very well done. I wasn’t looking forward to doing this job, you definitely made it a lot easier.
Good job
Your video saved my day as I had replaced the ignition coil on the FS90 and to get to the bottom screw on the ignition coil , I had to remove the white housing where the shaft connects and later I noticed that the throttle cable was just hanging lose.
So I took all the stuff off to get to the carb throttle lever and did not matter how I attached the cable ist always fell out and the reason is I was routing it the wrong way as I did not remove it ,l so did not see how it was attached. So after over an hour I checked RUclips and seen your amazing video and that saved me. Thanks for posting it.
Without this video I would never got it back together.
😤
Thanks, well done, and doing it myself saves me a shop fee of $108/hour (can you believe the greed!). I took it apart, but wasn't sure of the spring placements. The throttle cable had worn almost through.
Was able to fix FS130 with this video. Minor differences. Big Thanks !
This video was extremely helpful to me. It's the only good tutorial I could find. Thank you so much!
thanks....i had to reference the video to get one of the springs back in properly. Appreciate the assistance!
Thanks for making this video. Saved me a load of bother. Thanks
Thank you for your videos. I have learned a lot from you.
My fs120 is stretched under the handle and was hoping I could just adjust or tighten it up some but not sure how yet. Probably should just replace it anyway. Thanks for the upload 👍🏼👍🏼
Great video very detailed nothing left out was a great help. Thanks
Great video, it made a tricky job easy. Lloyd, Norfolk UK.
Thanks, especally for showing us how to put the springs back on... they had popped out when I took it apart and I was stumped about which spring went where.
me to , lolol
Thanks you made that look easy and I sure appreciate your video on it, a very big help.
Saved my bacon 🥓
Borrowed my father in laws weed eater and the cable snapped on me. Of course he’d never believe that 😂 thanks!
THANK YOU FOR THE VIDEO. LOVED IT. HELPED SO MUCH
Exactly what I was looking for. Thank you!
Mike miller
Thanks for the video i couldn't do it without seen it. Excellent!!!
Your video's are very good and helpful. Thanks....
Epic how to mate, you saved me
Thanks for a very helpful video.👍💪🇺🇸
Well done sir - thank you for this video. Very helpful.
you save my life man , thanks
appreciate the vid ! im converting a fs 250 brush cutter from bicycle handles to a pistol grip handle and couldnt figure out how the cable & wires hooked up in the handle
You made it look easy.
Super cool video
Excellent tutorial! Thank you!
Hi Mike,,,,,Do that go for a stihl 100rx trimmer also.,,,My cable is little short,,,,,i torqx screw on top of carburetor going to cable,,,,,,but online i read,,,, it a slide next to your handle that u slide on your handle,,,,and slide the clip forward,,,,,,Thanks
Can you change that handell with the big 2 hand wheel handell? Tnx
I have a fs 85 r that I bought but it has a hedge trimmer on it is this possible
Thanks really helpful
Sound barely here
.i might be getting hard to hear.
Great videos you need to make the volume louder on them have trouble hearing you
Another vote for increased volume.
Turned weedeater on stuck in high throttle is this my problem
what the throttle cable assembly part number ?
Great job thanks.
Great video thanks!
Good video!!!!!,,,,Thanks
After the switch my throttle dose not won’t to work anymore and when I turn it on it just runs and runs
Anyone know if a cable for a fs90 works in the fs90r?
nice job
Exactly what I wantef
Where r u from??
No sound starting at 2:39 continuing with no sound until 3:11. Though something was wrong with the devices I’m watching this on. Nope. For some reason the maker of the video cut the sound off. Why? Opened and closed the RUclips app on my iPad, still no sound. Turn my iPad off and back on, still no sound. Finally fast forward and there is sound. Why you would cut the sound off like that is beyond me kind of annoying as I thought there was a problem on my end.
Cheers