Husqvarna Leaf Blower SPARK Issue DIAGNOSIS.

If your Husqvarna leaf blower won't start, this video will teach you how to diagnose it! Using a simple stepy by step process you'll save money and time too!
TOOLS I USE:
Engine Tachometer - amzn.to/3TE48GZ
Mityvac Pressure & Vacuum Tester - amzn.to/3vysI3V
Gasket Maker - amzn.to/4bIiygR
Vessel Screw Drivers - amzn.to/3ISewG2
Brass Hammer: amzn.to/3xkyuH6
Stanley Stump Vice - amzn.to/3waHuOw
Stens 750-120 Carburetor Adjustment Tools- amzn.to/4atkBV5
Powerbuilt- backtap - amzn.to/49I9305
Forceps - amzn.to/4a2ud9v
Zoom Oil Bottles - amzn.to/3TWZV2t
Mityvac Compression Tester - amzn.to/4aimaFS
Bondhus Hex Keys - amzn.to/3J2m8FL
Klein MM400 multimeter - amzn.to/3PI3Y02
Stahlwille Combination Spanners - amzn.to/3IY6fQI
Milwaukee 12v Impact Driver - amzn.to/3VEuxH4
Milwaukee 12v Impact Wrench - amzn.to/4aPESVd
Milwaukee 12v 90 degree Grinder - amzn.to/4czLiJp
No-spill gas can - amzn.to/3TDfWcb
Any links to products are likely to affiliate links and I may earn a small commission from qualifying purchases with no additional costs to you. Thank you!
#husqvarna #ignition #smallengine #repair #2strokeengine #leafblower

[@haneyoakie14]

I had never thought about that safety issue. Thank you for teaching us.

[@VintageEngineRepairs]

Me neither until seeing how it works 😂

[@grasscutterpalmer3746]

great video tom glad you found out what was wrong with it I am having problems with a airbos leaf blower I have put a new carb on it and tuned it but still not getting power

[@VintageEngineRepairs]

Ah no! Best of luck with finding the issue 👍👍

[@TheLawnmowerLady]

Nice video! I've gotten oddball readings from coils on occasion (read: unable to reliably duplicate) when I still have them attached to the engine. In my past life on component level testing and repairs, I learnt to remove the component from the circuit before testing. I think that spilled over to my small engine repairs. Do you ever add any top end lube when turning the engine over with a power tool?

[@VintageEngineRepairs]

Very good call for adding oil, I just didn’t want it to splash around everywhere, I believe it still draws in fuel without the plug as the vacuum is below the rings? Not sure! I take coils off the engine when I do points ignition as the capacitor can mess with you :) thanks for sharing and lovely chatting earlier!

[@tinkeringtaylor3053]

Good information, Tom well done for solving the problem 👏🏻

[@VintageEngineRepairs]

Thanks for watching Nev!

[@mrtennessee6862]

Great job again bud.

[@VintageEngineRepairs]

Thanks mate 👍

[@jjrotogeek]

good show brother!

[@VintageEngineRepairs]

Thanks mate!!

[@petefroud5308]

Tom where did you get that little rev checker from.

[@VintageEngineRepairs]

It’s an Oppama PET 2100-DXR. It’s stupidly expensive and not necessary, you can get a cheaper just as good one!

[@Big_Johns]

Nice work on the trouble shooting Tom, the outcome made sense. 👍

[@VintageEngineRepairs]

Thanks John :)

[@GuysPlayingWithTools]

Having the spark not come back immediately is odd for sure. I thought about the circuit for a while, and heat seemed to be the only factor... but it's not hot.

[@VintageEngineRepairs]

Haha I think you missed the part of the video where I figure it out 😂

[@GuysPlayingWithTools]

@@VintageEngineRepairs No, I was just thinking out loud. I have seen hot ones do that every now and then, where they work again after cooling but there is a bit of time where they won't run.

[@williamemerson1799]

Dang, who'da thunk it! Id'a been the guy throw'in tools. Old dog, new tricks applies here, meaning me. Time for a Fosters, 👍🍻

[@VintageEngineRepairs]

Haha be kind to yourself, we can all learn and all get better :)

[@cbnx82703]

Hey Mate , what country are you in ?

[@VintageEngineRepairs]

Australia :)

[@cbnx82703]

Sticky Zener Diode …!

[@VintageEngineRepairs]

Thanks for watching !