How to install Shingle Ridge Cap

installation of roofing shingle ridge cap . peak of the roof.
#Roof #roofing #shingles #shingleroof #shingling #house #project #work #Remodel #fixerupper #reconstruction #job #construction #newconstruction

[@Christopher-p6s7h]

Thank you for your helpful videos very grateful for sharing w us 👍

[@NYAG]

Welcome!
For support, if you haven't already, please subscribe and like.

[@zane4utwo]

Thank you for this informative video. Nice. I think it's a job well done

[@NYAG]

Welcome!!
For support, please subscribe if you haven't already.

[@elijahemmons1999]

That is exactly what I needed to see so I can add that to my list of construction knowledge!

[@NYAG]

Good! Happy constructing!!!

[@linvol20]

Is this the same process for shingles over ridge vents?

[@NYAG]

Correct! 👍

[@gregsmith3873]

You didn't show the most important part, where the three runs come together.

[@NYAG]

You are right. I also didn't have the finishing cap. Next roof I do, I'll try to make sure and get that.

[@gregory4247]

Cut them square,fewer cuts no scrap and the square edge helps line them up.nice hitahtci gun.also pop a line,and also nail on the tar line.two nails per cap.

[@vtwrench1]

My ridge caps are showing signs of age , but the rest of the architecture shingles are ok. Can I replace ridge caps only ??

[@NYAG]

Yes, you can! If you have a ridge that runs into a slope like this one does, then it will be tricky getting it underneath the others.

[@clivehurdle2274]

Do you.need to.heat the tar strip so.they all get stuck down

[@NYAG]

Overtime it bonds together with the summer heat.

[@snort455]

Well done. thanks for

[@NYAG]

Thank you,
For support, please subscribe if you haven't.

[@TeofiloAdrisola]

magkano 1box ng shengles.

[@NYAG]

Depends on the kind of shingles you want.

[@larrycrookshanks1646]

You are cutting way to much off of each side of the caps. A 1/4" is more than enough. The reason that manufacturers make pre-made caps is so that there are 4 nails in each cap. And you don't cut the outside factory edge. The way your installing each cap is only getting 2 nails.

[@NYAG]

4 nails on each side!? Seams like more then needed...
Good to know bout the ¼" as I was just eye balling cuts.

[@larrycrookshanks1646]

@NYAG When you use 2 nails they catch the previous cap thus holding each cap with 4.

[@themayorbnb]

Had a roofer tell me it was "against code" to cut your own caps. Who's got a code reference for me???

[@NYAG]

Probably varies per state / county. Could be, but I wouldn't see why. so I honestly couldn't tell you.

[@1cedar185]

lol

[@Goofy.Roofer]

Buy breakaway bum